Lattice Sentry I²C Filter IP Core - Lattice Propel Builder User Guide

2022-03-23
■Introduction:
●SMBus Relay with filter (named I²C filter in this document) is designed to function as an invisible relay from the point of view of both Master and Slave devices on the bus. It is meant to be directly attached to the Master port and protect all Slave devices against malicious traffic generated from the Master port based on a whitelist of allowable commands set by the host (such asCPU, FPGA RoT design, and others). The filter IP is the subset of the SMBus protocol. SMBSUS# and SMBALERT# are not supported.
●The design is implemented in Verilog HDL. It can be configured and generated using the Lattice Propel™ Builder software. It can be implemented using the Lattice Radiant™ software and the Lattice Diamond®Place and Route tool. The module registers are accessed by the host (such asCPU, FPGA RoT design, and others) using a 32-bit Advanced High-performance Bus -Lite (AHB-Lite) interface.

Lattice

Lattice Sentry I²C Filter IP CorePropel Builder

More

More

User's Guide

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

December 2021

Revision 1.0

FPGA-IPUG-02166-1.0

1 MB

- The full preview is over. If you want to read the whole 24 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: