SPICE Device Model Si7223DN Vishay Siliconix Dual P-Channel 30 V (D-S) MOSFET
●DESCRIPTION:
■The attached SPICE model describes the typical electrical characteristics of the p-channel vertical DMOS. The sub-circuit model is extracted and optimized over the - 55 °C to +125 °C temperature ranges under the pulsed 0 V to 10 V gate drive. The saturated output impedance is best fit at the gate bias near the threshold voltage.
■A novel gate-to-drain feedback capacitance network is used to model the gate charge characteristics while avoiding convergence difficulties of the switched C-gd model. All model parameter values are optimized to provide a best fit to the measured electrical data and are not intended as an exact physical interpretation of the device.
●CHARACTERISTICS:
■P-channel vertical DMOS
■Macro model (subcircuit model)
■Level 3 MOS
■Apply for both linear and switching application
■Accurate over the -55 °C to +125 °C temperature range
■Model the gate charge
|
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
09-Oct-17 |
|
Rev. A |
|
77830 |
|
113 KB |
- +1 Like
- Add to Favorites
Recommend
- Firstohm‘s Superior Anti-Surge Wire Wound Axial Resistor SSWA Series With a low-temperature coefficient and a wide temperature range
- EPC Launches 2kW, 48 V/12 V DC-DC converter for More Efficient, Smaller, Faster, Bidirectional Converters for Mild-Hybrid Cars
- TT Electronics EBW5216 Busbar Shunt Resistors for High Current Measurements in The Hundreds of Amps Range
- How To Use An EPC Development Board to Evaluate The Performance of A Given GaN FET or IC in Common Applications?
- How to Design a 2 kW 48 V/12 V Bi-Directional Power Module with packaged eGaN® FETs
- The Differences between MOS Tube and IGBT Tube
- Vincotech‘s fastPACK 0 MOS and fastPACK 1 MOS Modules Featuring Cost-effective H-bridge Topology with MOSFETs
- MOS Switch Tube Selection and Principle Application
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.