Acroview Programmer AP8000 Support the Programming of TI Texas Instruments Fuel Gauge BQ27500DRZR-V130

PublishTime： 2023-08-26 Article Source：PTCHIP News

Core Recording Micro Semiconductor recently released the latest automated chip programmer software update and a list of newly supported chip models. Among them, the programming of TI Texas Instruments power meter BQ27500DRZR-V130 has been programmed by Core Recording Micro's general programming platform AP8000.

The BQ27500DRZR-V130 Side Li-ion Battery Fuel Gauge is a microcontroller peripheral that provides fuel gauging for single-cell Li-ion battery packs. The device requires little to no system microcontroller firmware development. The BQ27500DRZR-V130 Texas Instruments Fuel Gauge sits on the system board and manages either an embedded battery (non-removable) or a removable battery pack.

The BQ27500DRZR-V130 uses a patented impedance tracking algorithm for fuel gauging and provides information such as remaining battery capacity (mAh), state of charge (%), no-load runtime (minutes), battery voltage (mV), and temperature (°C).

When using the BQ27500DRZR-V130 for battery fuel gauging, only the battery pack + (P+), battery pack - (P-) and thermistor (T) need to be connected to the removable battery pack or embedded battery.

Functional block diagram

The AP8000 versatile programmer independently developed by Core Micro Semiconductor includes three major parts: a host, a backplane, and an adapter seat.

The host supports USB and NET connections, allowing multiple IC programmers to be networked to achieve the purpose of simultaneously controlling multiple programmers to burn at the same time. The built-in chip safety protection circuit ensures that even if the chip is reversed or a short circuit is caused by other reasons can be detected immediately and the power will be cut off to ensure the safety of the chip and programmer. Embedded high-speed FPGA greatly accelerates data transmission and processing. There is an SD card slot on the back of the main unit. Put the project file produced by the PC software into the root directory of the SD card and insert it into the card slot. The project file can be selected, loaded, and burned through the buttons on the programmer. command, in order to achieve the purpose of operating without a PC, which greatly reduces the cost of PC hardware configuration, and can be conveniently and quickly matched with the working environment.

AP8000 makes the mainframe more expandable by adding an adapter board to the backplane. Currently, it supports devices produced by all mainstream semiconductor manufacturers, including TI, ST, Microchip, Atmel, Hynix, Macronix, Micron, Samsung, Toshiba, etc. Supported device types include NAND, NOR, MCU, CPLD, FPGA, EMMC, etc., and support file formats including Intel Hex, Motorola S, Binary, POF, etc.

+1 Like
Add to Favorites

Recommend

Technical Resources

More>

New Products & Solutions

More>

This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.

Integrated Circuits