CBM555 OPERATION INSTRUCTION
●The CBM555 is CMOS RC timers providing significantly improved performance over the standard TLC/NE555 and 355 timers, while at the same time being direct replacements for those devices in most applications. Improved parameters include low supply current, wide operating supply voltage range, low THRESHOLD, TRIGGER and RESET currents, no crowbarring of the supply current during output transitions, higher frequency performance and no requirement to decouple CONTROL VOLTAGE for stable operation.
●Specifically, the CBM555 is stable controller capable of producing accurate time delays of frequencies.
■Features:
●Low Supply Current.
●High speed operation – 500 kHz guaranteed.
●Wide operation supply voltage range – 2 to 18 volts.
●Timing from microseconds through hours.
●Operates in both astable and monostable modes.
●Adjustable duty cycle.
●High output source/sink driver can drive TTL/CMOS
●AEC 100 Qualified
|
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
SOP-8 |
|
English Chinese Chinese and English Japanese |
|
2022/6/18 |
|
|
|
|
|
649 KB |
- +1 Like
- Add to Favorites
Recommend
- Corebai CBM317 Adjustable 3−terminal Positive Voltage Regulator Capable of Supplying in Excess of 1.5A over an Output Voltage Range of 1.2V to 37V
- Corebai New Dual Comparator CBM2903 with Supply Range of +2V to +30V and Low Input Offset Voltage
- A Real-time Clock IC with Two-wire Consecutive Interface
- CBM9001A Embedded USB Host Controller, Operating Full Speed at 12 Mbps with 256-byte Internal SRAM Buffer
- Dual, 16-bit, 125MSPS ADC CBM16AD125, Features A Multistage, Differential Pipelined Architecture
- Bringing WIFI RF Front-end Chips, Low-noise Amplifiers, 5G Small Base Station RF Chips, CHIPBETTER Announced a Distribution with Sekorm
- CMOS Operational Amplifiers CBM8557/8/9 with Very Low Offset Voltage and Near-zero Drift Over Time and Temperature
- ROHM Develops Ultra-Low-Power On-Device Learning Edge AI Chip,Enabling Real-time Failure Prediction Without Cloud Server Required
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.