STEP-200 2-AXIS,High-speed stepper Motor Controller
FIFO is used as a command buffer.
This buffer provides 1,360ms time buffer. Therefore, STEP-200 board is suitable for windows operation system. The STEP-200 board provides DOS, Windows 95, Windoes NT, LabView drivers. The user may use our encoder-300 encoder interface board to work with STEP-200 to implement a closed-loop stepper-motor control system.
●Features
■2-axis independent, simultaneous stepper motor control/servo motor control pulse input type)
■DOS, windows 95, windoes NT, LabView driver support
■Embedded CPU
■Command type interface
■Linear, circular interpolation
■Output pulse modes: CW/CCW or pulse/direction
■2500Vrms optical isolated signal output
■Output polarity can be programmable
■OEM version call
2-AXIS High-speed stepper Motor Controller 、 2-axis command-type, stepper motor controller board |
|
[ X-Y table control ][ Robotics ][ Mechanical positioning control ] |
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
1996/7/4 |
|
|
|
|
|
164 KB |
- +1 Like
- Add to Favorites
Recommend
- How to Convert 110V AC to 12 Volt DC: A Step-by-Step Guide
- UNIMOTION‘s Stepper Systems Offering a Complete Solution of a Stepper Motor, Drive and Cables
- Stepper Motor Drivers with Built-in Micro-stepping Algorithm Solveing the Jitter and Noise Problems
- Designing an AC-DC Converter Circuit: A Step-by-Step Guide
- SinoGNSS Data Link Module Introduction and Configuration Step by Step
- The New RA6T1 Motor Control Rssk:Only Three Simple Steps to Use
- SANYO DENKI Develops Stepping Systems Featuring High Torque and Low Vibration
- How to control a step motor with an Arduino
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.