VL600104 ACCESSORIES LOGIC MODULES 1700

2021-12-24
●It is often the case that the signals of many sensors are linked in an application in order to provide a statement about an operational state.
●If this linkage is adopted in the control unit, it is necessary to run the signals of each sensor up until there via leads, and process them in the control program.
●In many cases, it would be sufficient to link the sensor signals to one another on-site and only transmit one linked end-signal to the control unit.
●ipf electronic logic distribution terminals are used for this purpose. According to the module, up to 8 sensors can be connected and logically linked to one another.
●AND and OR versions are available as logical variants. The user can directly see which signals are pending and/or which are missing (as the case may be) by means of LED status display of the logic modules. The status of the linked end signals is similarly shown via output LEDs.
●The 2 x 2-way / 2 x 4-way types have two separated signal outputs. In these types the input signals of the right and left module halves are linked independent from each other.
●If, in the case of an AND module, an input slot cannot be taken up by a sensor, a so-called “jumper plug“ can be supplied.

IPF ELECTRONIC

VK500325VK200F25VK000004VK000035VL600104VL600108VL600114VL600118VL600124VL600128VL600134VL600138VK200325VK200321VK500321VKA00325VKA00321VK100F21VK100F25VK200F21VK500F21VK500F25

More

Part#

LOGIC MODULES

More

More

Datasheet

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

2019/4/11

1.2 MB

- The full preview is over. If you want to read the whole 4 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: