Select Model SRN Series Semi-shielded Power Inductors PRODUCT CHANGE NOTIFICATION
2021-07-15
Riverside, California –September 24, 2019– Effective December 5, 2020 April 3, 2021, the manufacturing location for select Bourns® Model SRN Semi-shielded Power Inductors will be relocating to a larger manufacturing facility to accommodate increasing production demands.
When the relocation is completed, the higher capacity, cross-town facility in Malaysia will enable Bourns to expand its production capacity for these popular chip inductors. Advanced Product Quality Plannning (APQP) will be utilized and reliability tests on samples produced from the new plant will be performed to ensure ongoing AEC-Q200 compliance, and PPAP reports for applicable part numbers will be updated.
There will be no design, material or manufacturing process change as a result of the manufacturing plant relocation. The form, fit, function, quality, reliability, production lead time and the country of origin of these components will remain the same. Affected part numbers are listed on the next page.
When the relocation is completed, the higher capacity, cross-town facility in Malaysia will enable Bourns to expand its production capacity for these popular chip inductors. Advanced Product Quality Plannning (APQP) will be utilized and reliability tests on samples produced from the new plant will be performed to ensure ongoing AEC-Q200 compliance, and PPAP reports for applicable part numbers will be updated.
There will be no design, material or manufacturing process change as a result of the manufacturing plant relocation. The form, fit, function, quality, reliability, production lead time and the country of origin of these components will remain the same. Affected part numbers are listed on the next page.
- The full preview is over,the data is 2 pages -
- +1 Like
- Add to Favorites
Recommend
More>
- Yint Electronics Recommends the TVS Model SMBJ6.5CA or P6SMB6.8CA for Surge Protection of Smart Meters
- Keysight Announces New Device Modeling Software to Enable One-Stop Workflow
- TE Model 41 Crash Test Accelerometer: Designed for Crush Zone Testing
- The Model EGAS-S398C NCAP Pedestrian Impact Test Sensor Available in Ranges from ±50g to ±2000g
- Wideband Gap Semiconductors: What Modeling Challenges Must We Overcome
- Low-Frequency Noise Modeling When Quantum Chips Are Getting Noiser
- Why Can the Servo Motors Accurately Control the Rotation of the Model Aircraft？
- How to Build AMI Models for DDR5 Memory Interfaces
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
