Installation Instruction of Drop In Isolator & Circulator
The Drop in Isolator/Circulator is usually installed on the circuit board.In this paper,UIY will introduce Installation Instruction of Drop In Isolator & Circulator.
The following is the installation instruction:
1、lotting on the circuit board to locate the drop in part. (The depth of the slot depends on the distance from the pin to the ground.)
2、Solder the pin onto the circuit board (welding temperature <180°).
3、Do not put too much solder paste, and pay attention to the VSWR match of connection port.
4、Fix the 4 mounting holes onto the PCB with screws.
5、Please make sure the bottom is well grounded.
Note: The picture above is just for quick-understanding of the installation, no any solution provided here.
- +1 Like
- Add to Favorites
Recommend
- Smiths Interconnect’s Isolator is Connecting with (Potential) Life on Jupiter’s Moons
- X-band RF Isolator and Circulator
- GRL Solar Power Solutions: Isolator Switch, Fuse Switch Disconnector And HRC Fuse Link
- The Anatomy of a Microstrip Isolator and Circulator: Understanding the Basics of Microwave Microstrip Isolator and Circulator Technologies
- Digital Isolator Selection Starts with a Good Understanding of Datasheet
- Digital Isolator Devices That Can Protect 24 V Digital Inputs & Outputs in Industrial Environments
- Nanochap Neurostimulation Chip Stim Engines Series ENS001 Features Higher Precision and Stability in Foot Drop System
- Installation of UIY Surface Mounting Isolator/Circulator
This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.