Installation of UIY Surface Mounting Isolator/Circulator
UIY Surface Mount Isolator and Circulators, featured by its small size, easy to install by reflow soldering, offer high frequency and rich frequency range which are one of the popular choices among our customers.
The Surface Mount Isolator/Circulator is easy to install because it does not require complicated installation skills and wiring. All you have to do is to solder and install it on the board applied.
So how to install the surface mount products? here are the steps:The Surface Mount Circulator or isolators can be installed by reflow soldering.
Firstly, Pad design:
the pad design is decided by pin size, it is required to make a pad for each pin. For example, if the pin size of Circulator is Φ1.2mm, we recommend to make a pad size by 1.5mm;
Secondly, make a pad at the bottom too, and ground the bottom (As shown below).
Note: Please don’t put too much solder paste, or else the solder paste will overflow around after putting the Circulator on, which may cause a short circuit at the bottom of the three pins.
In addition, the installation method of the surface mount isolator and the surface mount circulator are the same.
Recommended for small size Surface Mount Isolator/Circulator
01
02
- +1 Like
- Add to Favorites
Recommend
- UIY Released New 180° 3dB UIY2T2HC4040A, Operating Over 6-18GHz Ultrawide Band, Insertion Loss Less Than 1.5dB
- UIY INC. Exhibits at 2024 IMS Washington D.C. 18th~21th June
- 5 Clues Help Understanding the DBS Band
- Things You Need to Know About Combiner and Duplexer
- Reverse Power and How It Is Measured
- Frequency Bands Suitable for Satellite Communications
- Microstrip Isolator/Circulator Mounting Instruction Manual
- Installation Instruction of Drop In Isolator & Circulator
This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.