CN3063/CN3065/CN3722 Solar charge management chip selection
●Current source IPH produce the current and photovoltaic cells is directly proportional to the brightness. When no load is connected photovoltaic cells, almost all the current flows through the diode D, whose forward voltage determines the photovoltaic cells of the open circuit voltage (VOC). The voltage will vary due to the different characteristics of various types of photovoltaic cells. However, for most silicon photovoltaic cells, the voltage is between 0.5V to 0.6V, which is also a pn junction diode forward voltage.
●Actual PV cell parallel resistance (RP), leakage current is very small, and the RS will produce a connection loss. Because of the series resistor (RS), the voltage will be slightly decreased. Sometimes, however, through the internal diode current is too small to cause enough bias voltage across the diode will be a sharp decline with increasing load current. Finally, if all the current only flows through the load without flow through the diode, the output voltage will be zero. This current is called the photovoltaic cell short circuit current (ISC). ISC and VOC are the main parameters of the photovoltaic cells. Therefore, the photovoltaic cells is that the current limit “type power supply”, its output voltage will decrease with the increase of the output current and load current reaches the short circuit current is reduced to zero.
|
|
Technical Documentation |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
2012/2/13 |
|
Rev 0 |
|
|
|
78 KB |
- +1 Like
- Add to Favorites
Recommend
- Slkor SL4054 Constant-current/Constant-voltage Linear Charger for Single Cell Lithium-ion Batteries
- A Single Cell Lithium-Ion Battery Charger Using a Constant-Current/Constant Voltage Algorithm-A4055
- ROHM Develops a New Op Amp that Minimizes Current Consumption, Improving Power Savings in Consumer and Industrial Equipment
- WattUp®Wireless Charging for Consumer Electronics, Ensuring Consistent Uptime
- Digging Deeper into Dielectric Constant for PCB Materials
- Xinyun Tech Launched 100% Home-made 4x25/28G LR4 Turnkey Solution, with Conservative Power Consumption of Only 3W and Extinction Ratio above 6dB
- The Pros and Cons of Different Filter Structures
- Catheter Design and Material Considerations for Sensors
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.