RS0102 2-Bit Bidirectional Voltage-Level Translator for Open-Drain and Push-Pull Application

2020-07-21
This two-bit non-inverting translator is a bidirectional voltage-level translator and can be used to establish digital switching compatibility between mixed-voltage systems. It uses two separate configurable power-supply rails, with the A ports supporting operating voltages from 1.65V to 5.5V while it tracks the VCCA supply, and the B ports supporting operating voltages from 2.3V to 5.5V while it tracks the VCCB supply.This allows the support of both lower and higher logic signal levels while providing bidirectional translation capabilities between any of the1.8V, 2.5V, 3.3V and 5V voltage nodes.
When the output-enable (OE) input is low, all I/Os are placed in the high-impedance state, which significantly reduces the power-supply quiescent current consumption. OE has an internal pull-down current source, as long as VCCA is powered.
To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pull-down resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver.
The RS0102 is available in Green SOT-23-8 packages. It operates over an ambient temperature range of -40°C to +85°C.

RUN-IC

RS0102RS0102YH8RS0102YUTDS8RS0102YVS8

More

Part#

2-Bit Bidirectional Voltage-Level Translator

More

I²C/ SMBus ]UART ]GPIO ]

More

Datasheet

More

ESD(HBM,5000V) 、 ESD(MM,400V)

More

Please see the document for details

More

More

SOT-23-8;DFN-1.4X1-8L;VSSOP8

English Chinese Chinese and English Japanese

REV A.1

1 MB

- The full preview is over. If you want to read the whole 19 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: