How to use Silicone Adhesive
How to use Silicone Adhesive?
1. Access: One-component silicone glue can be used immediately, and it can be easily shot out of the bottle with a glue gun.
2. Bonding:
A. Completely wipe the metal and plastic surfaces to remove oil stains. First, rinse all surfaces of the plastic with acetone, and polish the rubber surface with sandpaper, then wipe with acetone.
B. Spread the silicone glue evenly on the surface of the ready object. If you are bonding two surfaces together, you can locate one side first, and then squeeze the other side with enough force to squeeze out the air, but Be careful not to squeeze the glass glue.
C. Put the bonded device at room temperature until the glue is cured.
3. Sealing: When silicone glue is used for sealing, follow the same steps as mentioned above, squeeze the glue into the joint surface or gap to make the glass glue fully contact the surface.
4. Cleaning: The glass glue can be wiped off with a cloth or paper towel before it is cured. After it has been cured, it must be scraped off with a spatula or scrubbed with solvents such as xylene and acetone.
- +1 Like
- Add to Favorites
Recommend
- Classification of Silicone Adhesive
- WACKER Presents Highly Adhesive Silicone Gel for Fixing Electronic Components at COMPAMED 2023
- Uses of Silicone Adhesive
- Identification Method of Silicone Adhesive
- Silicon Labs Simplifies IoT Development with Simplicity Studio 5
- Silicon Labs Z-Wave Wireless Selected for Johnson Controls Next Generation Qolsys Smart Home Panel
- Silicon Labs Strengthens Isolated Gate Driver Portfolio
- News | Silicon Labs and Amazon Collaborate on Sidewalk, a New Shared Network for IoT Consumer Devices
This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.