Model 2188 Turntable 1.0-m, 1.2-m, 1.5-m, 2.0-m User Manual
●The top of the turntable is conductive with a continuous ground brush to electrically couple it to the ground plane. The ground brushes are attached directly to the chamber floor by the floor flange and are in continuous contact with the turntable top. The brushes point downward from the floor flange.
●The drive motor and gearing are located beneath the platform. The Model 2188 is powered by an electric motor through a worm gear box with a chain and sprocket final drive. The top of the turntable is removable to provide easy access in the event that service is required. The electronics are located in a shielded enclosure. Signal I/O is through fiber optic cable.
●To prevent over-travel of the turntable in either direction of movement, hard limits are provided in the form of pins that actuate switches located below the tabletop. These pins allow limits to be set and allow as much as two full rotations. Rotation speed can be varied from the front panel of the controller or through the IEEE-488 interface bus.
Turntable 、 electric-powered, variable- speed turntable platform system |
|
|
|
User's Guide |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
January, 2018 |
|
Revision E |
|
|
|
846 KB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.