Model 2181 Electric-Powered Turntable 2-Meter, 3-Meter, 4-Meter, 5-Meter User Manual
●The top of the turntable is conductive with a continuous ground brush to electrically couple it to the ground plane. The ground brushes are attached directly to the chamber floor by the floor flange, and are in continuous contact with the turntable top. The brushes point downward from the floor flange.
●All models utilize a pinion and gear drive with a gear reducer and electric motor located beneath the platform. The bearing on which the turntable rotates has the drive teeth cut directly on the outside and will easily support most Equipment Under Test (EUT). Support for the turntable includes casters that aid in the support of cantilevered loads on the outside of the turntable.
●The turntable top is sectional to provide easy access if service is required. On standard models, a 15-cm hole is provided in the center of the turntable to accommodate customer supplied cabling to and from the EUT.
●To prevent over-travel of the turntable in either direction of movement, hard limits are provided in the form of pins that actuate switches located below the tabletop. These pins allow limits to be set and allow as much as two full rotations. Rotation speed can be varied from the front panel of the EMCenter or through the IEEE-488 interface bus.
Electric-Powered Turntable 、 electric-powered turntable platform system |
|
[ EMI compliance testing ][ indoor use ][ outdoor use ] |
|
User's Guide |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
January, 2018 |
|
Revision E |
|
|
|
877 KB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.