FSP850-50FGPH3 Meet 80 PLUS Platinum, RoHS Compliant 850 Watts FLEX Switching Power Supply

2024-11-22
●Features
■PM Bus Revision 1.2.
■Active Power Factor Correction (PFC) meet EN61000-3-2
■High efficiency and reliability
■Compatible with European Union Directive 2011/65/EU & (EU)2015/863 (Restriction on Hazardous Substances).
■Remote ON/OFF function
■Internal 12V DC fan included
■Low noise and ripple
■Output over voltage, short circuit, and over current protection
■100% Hi-pot, ATE, and burn-in tested
■Re-settable power shut down
■Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation
■Approved by CB 62368 & 60950-1 2 nd , EMC. CUL/UL TUV, FCC
●Specification
■Temperature Range: Operating: 0°C ~ +50°C on full load; storage & shipping: -20°C ~ +80°C
■Humidity:
▲5~90%RH,Non-condending on operating.
▲5~90%RH,Non-condending on storage
■Dielectric Withstand: Primary frame ground 1800V AC for 2 second
■Efficiency: Typical > 92%
■Altitude: Applied for tropical Climates and use at altitudes not exceeding 5000M above sea level.
■Meet Energy Star 5.0 & ErP : The 5Vsb Standby efficiency is measured with the main outputs off (PS_ON# high state). Standby efficiency should be as shown in below table.
■Rise time: Less than 20ms
■Hold-up Time: 17 ms minimum at nominal input voltage for 75% maximum load.
■Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
■Leakage Current: Less than 3.5mA at 264Vac, 63Hz
■MTBF:A minimum predicted MTBF (MIL-HDBK-217) of 100,000 hours of continuous operation at +25°C.
■Dimensions (LxWxH): 220x81.5x40.5mm / 8.67x3.2x1.6inch

FSP

FSP850-50FGPH3

More

Part#

850 Watts FLEX Switching Power Supply

More

More

Datasheet

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

2019/3/26

43 KB

- The full preview is over,the data is 1 pages -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: