D-73P3 bypass switches installation instructions
●Introduction
◆Eaton's Cooper Power™ series D-73P3 bypass switch is a single-phase 3-pull, 3-blade hookstick-operated switch. It is used for manually disconnecting a recloser or regulator without disturbing normal electrical service. The D-73P3 switch does not have current making or breaking capability without use of portable loadbreak tools.
●Read This Manual First
◆Read and understand the contents of this manual and follow all locally approved procedures and safety practices before installing or operating this equipment
●Additional Information
◆These instructions cannot cover all details or variations in the equipment, procedures, or process described nor provide directions for meeting every possible contingency during installation, operation, or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for the user's purpose, please contact your Eaton representative.
●Acceptance and initial inspection
◆Each switch is in good condition when accepted by the carrier for shipment. Upon receipt, inspect the shipping container for signs of damage. Unpack the switch and inspect it thoroughly for damage incurred during shipment. If damage is discovered, file a claim with the carrier immediately.
●Handling and storage
◆Be careful during handling and storage of the switch to minimize the possibility of damage. If the switch is to be stored for any length of time prior to installation, provide a clean, dry storage area.
●Standards
◆ISO 9001 Certified Quality Management System
●Installation procedure
◆The switch must be properly selected for each installation with consideration to continuous current, BIL, and rated voltage.
●Switch configurations
◆D-73P3 style bypass switches are available for both right (standard) and left bypass opening configuration. Left opening configuration is indicated by a “L” catalog number listed on nameplate. When opening switch with standard right configuration, the bypass blades opens to the right of the operator when standing in front of the switch. A left opening by-pass opens to the left. Operation procedures do not change based on right or left opening of the bypass blade.
|
|
User's Guide |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
April 2016 |
|
Rev 00 |
|
MN008005EN |
|
514 KB |
- +1 Like
- Add to Favorites
Recommend
- Citroën Ami : a 100% Electric Vehicle for New Mobility a 48V Electric Unit Which Allows the Electric Motor to Be Powered
- GSA Expands Contract with Eaton to Include Electric Vehicle Supply Equipment, Help Accelerate Low-carbon Federal Infrastructure Projects
- Eaton and Charge Enterprises Target U.S. Fleets to Accelerate Infrastructure for Electric Vehicle Charging
- UNIMOTION Mini Electric Cylinder MCE and Mini Electric Slider MSCE
- ROHM‘s 4th Generation SiC MOSFETs to be Used in Hitachi Astemo‘s Inverters for Electric Vehicles, Contributing to Longer Cruising Range and Smaller Systems in Electric Vehicles
- Electric Vehicle Malfunctions Due to Lack of Fuses or Diodes
- The Electric Power Series: Empowering the Future with Electricity
- The Electric Power Series: Illuminating the World
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.