Silicon Labs(芯科科技) C8051F020/1/2/3 MCU数据手册

2023-08-31

The C8051F020/1/2/3 devices are fully integrated mixed-signal System-on-a-Chip MCUs with 64 digital I/O pins(C8051F020/2) or 32 digital I/O pins (C8051F021/3). Highlighted features are listed below; refer to Table 1.1 forspecific product feature selection.
With on-chip VDD monitor, Watchdog Timer, and clock oscillator, the C8051F020/1/2/3 devices are truly stand-alone System-on-a-Chip solutions. All analog and digital peripherals are enabled/disabled and configured by user firmware. The FLASH memory can be reprogrammed even in-circuit, providing non-volatile data storage, and also allowing field upgrades of the 8051 firmware.
On-board JTAG debug circuitry allows non-intrusive (uses no on-chip resources), full speed, in-circuit debugging using the production MCU installed in the final application. This debug system supports inspection and modification of memory and registers, setting breakpoints, watchpoints, single stepping, run and halt commands. All analog and digital peripherals are fully functional while debugging using JTAG.
Each MCU is specified for 2.7 V-to-3.6 V operation over the industrial temperature range (-45° C to +85° C). The Port I/Os, /RST, and JTAG pins are tolerant for input signals up to 5 V. The C8051F020/2 are available in a 100-pin TQFP package (see block diagrams in Figure 1.1 and Figure 1.3). The C8051F021/3 are available in a 64-pin TQFP package (see block diagrams in Figure 1.2 and Figure 1.4).

Silicon Labs

C8051F023-GQC8051F023-GQRC8051F023C8051F02xC8051F022-GQC8051F022-GQRC8051F022C8051F021-GQC8051F021-GQRC8051F021C8051F020-GQRC8051F020C8051F020-GQ

More

Part#

微控制器微处理器8K ISP FLASH MCU

More

通信设备 ]工业电子 ]汽车电子 ]消费电子 ]

More

Datasheet

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

2003年12月01日

Preliminary Rev. 1.4 12/03

6.5 MB

- The full preview is over. If you want to read the whole 272 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: