UMC3000-30H-E5-5M-3G-3D Ultrasonic sensor
■The sensor can be adapted to the specific requirements of the application by means of programming. There are two methods of programming.
▲1. Basic functions can be set using the teach-in process. These are the position of the switch points and the output function. The teach-in processis connected either with +UB (1 level) or -UB (0 level).
▲2. With a programming adapter (see Accessories) and the DTM module for PACTware, a comprehensive range of parameterisable functions is available. A male cordset with WAGO terminals is needed for the connection to the programming adapter (see Accessories).
■Note:
▲- The programming options are available in the first 5 minutes after switching on and are extended during programming. After 5 minutes without any programming activity, the sensor is locked to prevent programming.
▲- It is possible to exit programming without changing the sensor settings at any time. Simply stop any programming activity. After 10 seconds, the sensor exits programming mode and switches to normal operating mode with the last valid settings.
|
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
07/01/2021 |
|
|
|
45-4861B |
|
1.3 MB |
- +1 Like
- Add to Favorites
Recommend
- Made for Continuous Power Supply: PANJIT‘s New High Voltage Rectifiers for ORing Diode Solutions
- Lightweight and Vibration-resistant Connector for Commercial Use | Nextron
- Alliance Memory 5V Parallel NOR Flash Memory Solutions Offer Fast 55ns Access Times and Densities from 1M to 16M
- PANJIT‘s New Ultra-Low VF Bridge Rectifier Series: Optimizing Power Efficiency and Reliability Across Various Applications
- 5V Parallel NOR Flash from Alliance Memory was Available in Densities from 1M to 16M and Offer Access Times of 55ns
- ROV with Xsens MTi-3 Sensor Inside Performs Geotagged Visual Inspections Underwater
- Reducing Noise Issues in Microcontroller Systems with RENESAS MCU
- The History and Milestones of WIMA
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.