JUMO dTRANS T08 13:HART® transmitter (Pt100, J, K) Data Sheet
■ Slimline housing of 6 mm
■ Excellent EMC performance and 50/60 Hz noise suppression
■ Selectable < 30 ms / 300 ms response time
■ Pre-calibrated temperature ranges selectable via DIP-switches
●Application:
■ The 707113 temperature converter measures a standard Pt100, TC J and K temperature sensor, and provides an isolated active analog current and HART signal output.
■ High 3 port isolation provides surge suppression and protects the control system from transients and noise.
■ The 707113 can be mounted in the safe area or in Zone 2 / Division 2 areas.
■ Approved for marine applications. Technical characteristics
■ Flexibly powered by 24 VDC (±30%) via power rail or connectors.
■ A 60 ms fast response time with simultaneous sensor error detection when selected.
■ Selectable internal/external CJC.
■ Excellent conversion accuracy in all available ranges, better than 0.05% of span.
■ Meeting the NAMUR NE21 recommendations, the 707113 provides top measurement performance in harsh EMC environments.
■ The device meets the NAMUR NE43 standard defining out of range and sensor error output values.
■ A visible green LED indicates operational status of the unit and the input sensor.
■ All terminals are protected against overvoltage and polarity error.
■ High galvanic isolation of 2.5 kVAC.
■ Excellent signal/noise ratio of > 60 dB.
●Mounting / installation / programming:
■ Selectable HART mode with HART 7 revision protocol enables extended device programming.
■ Selectable DIP-mode for easy configuration of more than 1000 factory calibrated measurement ranges with HART read only feature.
■ The narrow 6 mm housing allows up to 165 units to be mounted per meter of DIN rail, without any air gap between units.
■ Wide ambient temperature range of -25...+70°C.
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
2020/03/31 |
|
V1.00 |
|
00698450 |
|
468 KB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.