ULTRA 3000
●Why use PC software for parameterization?
■Commands and parameters can be transferred to sensors via an RS 232 interface, if present. These commands can be used to output measured values, configure the evaluation process, switch outputs and/or analog output, set and query parameters, and control the general unit functions. This provides the user with an aid in optimally adapting the sensor to its specific application and visualizing parameters or mea-sured results.
|
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
09.09.2014 |
|
|
|
|
|
245 KB |
- +1 Like
- Add to Favorites
Recommend
- Maswell Lanuched a Ultra-Wideband SMD Chip Antenna 0806 footprint AN_UWB_CA_0806_T03 Covering the Frequency Range of 3000~10000MHz
- Ultra-low profile and Ultra-large current Co-fired power inductor-HTF series with an Ultra-low Loss and Ultra-large Current
- 3PEAK Unveils TPL8033, a Next-generation Linear Regulator Featuring Ultra-low Noise and Ultra-high PSRR
- Long-lasting Floor Protection with Devcon® Ultra Quartz™ Coating
- InvenSense® Announces UltraPrint™ Mass-Manufacturable Ultrasound Fingerprint Touch Sensor Solution
- Nisshinbo‘s A dual audio operational amplifier NJM8830 featuring ultra-low distortion and ultra-low noise will start producing
- TDK Introduces Two New High-performance Ultrasonic ToF Sensors Integrating PMUT with an Ultra-low-power SoC
- Ultra-Fast Soft Recovery Diode Module F45D60U, Featuring Ultrafast Recovery Time, Low Recovery Loss and Soft Reverse Recovery Characteristics
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.