Cable Connector Class EA 180°, 270° and 360°: Links with up to 10 GBit/s Can be Easy
During maintenance, expansion and installation of new cabling, it's possible for a cable to be too short. What to do? Replacement of the entire cable will cause additional work and increase cost. Also, certain local conditions may not allow this.
The Cable Connector Class EA is the intelligent solution for a simple extension or connecting of data cable without the need for special tools. Thanks to its compact design and the angled variants, it can be used in a wide variety of applications, even in confined spaces. With a Class EA compliance, links with up to 10 GBit/s can be achieved without any problems. The cable connector is therefore a problem solution for almost any network infrastructure, and should be included in every toolbox as basic equipment!
The Cable Connector Class EA is the intelligent solution for a simple extension or connecting of data cable without the need for special tools. Thanks to its compact design and the angled variants, it can be used in a wide variety of applications, even in confined spaces. With a Class EA compliance, links with up to 10 GBit/s can be achieved without any problems. The cable connector is therefore a problem solution for almost any network infrastructure, and should be included in every toolbox as basic equipment!
Variants：
Lots of possibilities with the 180 °, 270 ° and 360 ° variants
The Cable Connector Class EA is available in three variants. The variants differ in the cable direction.
The angled variants 180°, 270° and 360° can be used to connect cables in a wide variety of situations.
Benefits
Application Examples：
Infrastructure relocation: e.g. workstation
Cable extension: e.g. cable too short
Repair: e.g. defective cable
Installation options：Known assembly principle
Technically, the Cable Connector Class EA is based on the installation principle of the METZ CONNECT C6Amodul. This results in not only a system of the products, but also a consistent and easy installation.
Relocation of existing infrastrucrure with C6A module
If the C6Amodul was used in an existing infrastructure, a relocation can be performed more easily and quickly since the loading piece of the C6Amodul can be used in the Cable Connector Class EA. Through this, only one side has to be connected again.
Accessory——Click & fix 19" carrier for cable connector
19" cable connector bracket for use as a consolidation point, for moving distributors or complete distribution cabinets.
- +1 Like
- Add to Favorites
Recommend
- Mission Critical: Maintain your RF cables and connectors 24 APR Mission Critical: Maintain your RF cables and connectors
- How Ribbon Cable Connectors Work
- Indoor Fiber Optic Cable with CPR Approval According to Fire Class B2ca, Suitable for MPO Connector Assembly
- Indoor Fiber Optic Cable 84173 with CPR Approval According to Fire Class B2ca
- Hosiden‘s High-performance FAKRA Cable connector Supporting Large-diameter, Low-loss Cables
- Greenconn’s New RAST Connector Solution with Cable Compatibility
- What is a Ribbon Cable Connector
- German connector brand METZ CONNECT reached a partnership with Sekorm
This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
