MPE-Garry Opened a Sample Prototype Testing Department
In December 2019, MPE-Garry opened a new Sample prototype testing department. The investment in new machines created additional capacities as well as opportunities for trials and tests on prototypes and series components.
"We need near-series stamped parts for product and manufacturability tests, ideally in the early project phase," explains Jörn Bargholz, General Manager of MPE-Garry. "The results of these tests increase our responsiveness if a tool adjustment is required. This, in turn, enables considerably better throughput times for the final progressive tool." To eventually end up with practical tools and excellent products, the samples are built from stamped-bent parts, even in the development phase. "This means we can implement pre-production series that later go into series production," explained Bargholz. This not only benefited MPE-Garry but also the customers - they could inspect and evaluate the results of the test runs on site.
Innovations for even more power
To optimally integrate the new prototype construction into the production process, the technical equipment was of the highest priority during the planning phase. Over a project room size of approximately 80 m2 between stamped part production and tool construction, there will be, therefore:
An SHP-400 servo-stroke press for punching and adjusting new progressive tools, for small-series production as well as for testing and operating sample prototype tools.
The Beger BT-150 bending machine for fast, flexible, high-precision bending, for example, laser-cut or etched boards for sample or prototype production.
In addition, this bending machine is used for the final stamping strip calculation for series tools.
An S9i stereo microscope to inspect and analyze cutting edges on active parts, stamped parts, and stamping strips. this enables the professionals to gain knowledge about the service life of the individual tools to increase them before the next maintenance interval.
The new high-performance press from Bruderer, the BSTA 410-110 high-speed automatic punching press, expands the already excellently equipped machine park to a total of eight Bruderer systems for series production.
MPE-Garry founds off the complete range of high-performance presses with:
the durable, consistently precise machine - and guarantees shorter production times
even higher productivity
high competitiveness in the future thanks to lower operating costs
- +1 Like
- Add to Favorites
Recommend
- Slkor MM5Z10V: A High-Quality Voltage Regulator with Impressive Performance
- The World‘s Best Performance IGBT Product That Responds to Energy Saving and High Performance of xEV
- Launching of Compact, High-Efficiency, High-Power DC Brushless High-Pressure Blowers (800W-type and 1,200W-type)
- LEMON Photonics 808nm and 850nm VCSEL Chips Feature High Efficiency, High Reliability, and Excellent High-temperature Performance
- High-speed Colibri® SMT Connectors in Additional Pin Count Options Meets the Requirements of PICMG COM Express® and SFF-SIG CoreExpress®
- 24-Bit Digital High Precision Differential Pressure Sensor ASM10D Series, Pressure Ranges from ±1kPa to ±1000kPa
- ATP N600Si/Sc PCIe Gen 4 x2 NVMe CFexpress Card:High-Speed Removable Storage for Industrial Applications
- High-Efficiency 850 Watt Modular Power Supply for Enhanced Performance
This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.