Certified According to EN 45545-2: Wevo Potting Compounds Products for Rail Vehicles and Railway Infrastructure
The German government is planning for Germany to be climate-neutral by 2045, including the mobility sector. The nation’s railways are to play an important role in achieving this goal. With increasing traffic volumes in both passenger and freight transport, the issue of safety will also play an increasingly important role. In the event of a fire, for example, it must be possible to evacuate the train quickly and prevent or at least slow down the spread of the fire. For this purpose, European test standard EN 45545-2 specifies EU-wide fire protection requirements for the materials and components used in rolling stock. Specially designed potting compounds from WEVO-CHEMIE GmbH meet the highest requirements of this standard and can therefore be used for electrical and electronic components in rail vehicles and railway infrastructure.
Plastics are widely used in rail vehicles and railway installations, for example as insulating materials in transformers, capacitors, sensors, relays, insulators, printed circuit boards, and batteries. In the event of a fire, the components and materials must meet certain performance levels defined by EN 45545-2. Categorization into the three “hazard levels” (HL) essentially depends on the hazard that arises during a fire.
To this end, the standard takes into account, on the one hand, the operation category of the rail vehicle, which depends on whether the vehicle is traveling on open track or for example mainly in tunnels. In addition, the design category is also relevant as for example, a freight wagon requires a lower level of fire protection than a double-deck passenger train. The location of the material or component, the exposed surface of the combustible material, and the subsequent application – whether furniture, electrotechnical, or mechanical equipment – also play an important role, as dangers may arise in the event of fire from flames, heat, smoke, and toxic gases.
WEVO POTTING COMPOUNDS MEET HIGH REQUIREMENTS AS SET BY EN 45545-2
Accredited test institutes have examined the suitability of specially designed Wevo potting compounds for use in rail vehicles and railway infrastructure. Their findings: The polyurethane-based products WEVOPUR 552 FLX and WEVOPUR 67210 FL successfully fulfilled the highest performance level HL3 in requirement sets R22 and R23 (electrotechnical products for interior and exterior use in rail vehicles). Several other products meet performance levels HL3 in R23 and HL 2 in R22, including an epoxy resin.
TARGETED PRODUCT DEVELOPMENT LEADS TO ADDITIONAL BENEFITS
In order to meet the desired performance levels, Wevo has tested a wide range of formulations and raw materials during product development. “In line with the requirements of the standard, particular attention was paid to achieving a combination of low flammability, low smoke density, and low smoke toxicity,” explains Andreas Arlt, Business Development Manager at Wevo. At the same time, in close cooperation with suppliers and OEMs from the world of railway engineering, the thermo-mechanical and dielectric properties have been optimized and easy processability ensured. “Furthermore, we have even realized positive impacts on the mechanical properties by using certain additives,” adds Andreas Arlt. “These include a lower coefficient of thermal expansion, higher tensile strength, and higher thermal conductivity.”
All products are also self-extinguishing in line with UL 94 V-0. In addition, some polyurethane potting compounds have a United Laboratories (UL)-registered RTI value of between 130℃ and 155℃– which means they can be used in class B and F insulation systems.
- +1 Like
- Add to Favorites
Recommend
- More power for supercapacitors – with the aid of Wevo potting compounds
- Temperature-resistant and Flame-retardant: Wevo Potting Compounds Materials with High UL Ratings
- Suitable for Drinking Water: Wevo Potting Resin Receives WRAS Approval
- Wevo Potting and Sealing Compounds Pass the Endurance Test, Protected Redox Flow Batteries From the Corrosive Electrolyte
- Custom Design And Efficient Production: Wevo Products for Automotive Lighting Systems
- Reliable and Durable Charging Infrastructure with Wevo Products
- Wevo Lannched a Battery Adhesive Systems for High-Performance EVs
- Optimizing HVDC Components Using Wevo Vegetable Oil-based potting Compounds to Ensure Electrical Insulation, Freedom from Partial Discharges and so on
This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
