Power Quality Anayzer iMC774,Class A (0.1%) accuracy in Compliance with EN61000-4-30
ISKRA' s POWER QUALITY ANALYZER iMC774 is an important device for permanent monitoring of power quality from its production (especially renewable), transmission, and distribution to final consumers, who are most affected by insufficient quality of voltage. Lack of information about the supplied quality of voltage can lead to unexplained production problems and malfunction or even damage to equipment used in the production process.
The iMC774 can be used for utility purposes (evaluation against standards) as well as for industrial purposes (monitoring supplied power quality).
iMC774 performs measurements in compliance with regulatory requested standard EN 61000-4-30 and evaluates recorded parameters for analysis according to parameters defined in European supply quality standard EN 50160:2011.
iMC774 stores measurements and quality reports in internal memory for further analysis over recorded measurements. By accessing recorded or real-time values from multiple instruments installed in different locations it is possible to gain the overall picture of systems’ behavior. This can be achieved with regard to iMC774 accurate internal real-time clock and wide range of synchronization sources support, which assure accurate, time-stamped measurements from dislocated units.
All required measurements, weekly PQ reports, and alarms can also be stored locally in internal memory. Stored data can be then transferred to a memory card or accessed through communication for post-analysis.
Features
Evaluation of the electricity supply quality in compliance with EN 50160 with automatic report generation.
Measurements of instantaneous values of more than 140 quantities including harmonics, flicker, power line signaling voltage, unbalance, etc...
Class A (0.1%) accuracy in compliance with EN61000-4-30.
Four quadrant energy measurement with class 0.2S for active energy, 8 programmable counters, up to four tariffs, tariff clock …
Automatic range selection of 4 current and 4 voltage channels (max. 12.5 A and 1000 VRMS) with 32 kHz sampling rate.
Recording all measured parameters including all voltage and current harmonics up to 65th, 32 adjustable alarms, anomalies, and quality reports in the internal memory.
Measurements of 40 minimal and maximal values in different time intervals (from 1 to 256 periods).
Frequency range from 16 Hz to 400 Hz.
Up to three independent communication ports (RS 232/485 up to 115,200 bit/s, Ethernet, and USB 2.0).
MODBUS, DNP3, and MQTT communication protocols.
Support for GPS, IRIG-B (modulated and digital), and NTP real-time synchronization.
Up to 20 inputs and outputs (analogue inputs/outputs, digital inputs/outputs, alarm/watchdog outputs, pulse input/outputs, tariff inputs).
Multilingual support.
Universal power supply (two voltage ranges).
144 mm square panel mounting.
User-friendly setting and evaluation software, MiQen.
- +1 Like
- Add to Favorites
Recommend
- The story of ISKRA low voltage switchgears
- Iskra Recognized Among the Best in ESG Development in Slovenia
- ISKRA Smart Energy Meters(WM3M4C)fully compliant with the German calibration law, known as Eichrecht!
- Iskra‘s Elka Took over a 50 Percent Ownership Stake in Elkakon
- Iskra and SuperFlink: Pioneering Electrotechnical Solutions for a Sustainable Future
- Iskra‘s Cooperation with Easelink on the eTaxi Austria Project
- Project completed - Iskra DZ9 Teleprotection equipment in operation at RTP 400/110 kV Cirkovce
- ISKRA Launches a new Power Quality Analyzer iMC784 used for utility purposesas well as for industrial purposes
This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.