During programming with RENESAS Flash Programmer(RFP), the processing stopped with the following error.E0000020 The program file exceeds the flash memory size of target device. Operation failed.How do I resolve this?
- 创建于2020-04-26
1answer(s)
-
- (0)
- In RFP V3.03,when data out of the range of memory in the device was detected,a warning message was displayed and processing continued.However,the warning is now handled as an error,and an optional function (to stop processing) has been added.This error arises when a file that includes data out of the range of memory in the MCU is selected.[Workaround]Check the project in which the program file is created,and then modify the program file not to create data out of the range of memory in the MCU.
- Published:2020-04-26
- +1 Like
- Add to Favorites
Recommend
More>
- Universal Programmer AP8000 Supports Programming FuDanWei‘s Serial Flash Memory FM25Q16A
- Acroview Programmer AP8000 Support the Programming of TI Texas Instruments Fuel Gauge BQ27500DRZR-V130
- Acroview Automated Chip Programmer Software Support the Programming of Haawking‘s Digital Signal Processor HXS320F28027PT*-ECD
- What is a Programmer?
- Micron M45PE 3V Page-erasable Serial NOR Flash Available Direct from Alliance Memory
- Alliance Memory to Highlight Latest SRAM, DRAM, Flash, and Storage Memory ICs at Embedded World 2022
- ACROVIEW Programmer Supports Chip Programming of AdvanceClip‘s 32-bit fixed-point digital proce
- The Benefits of Pseudo SLC (pSLC) Flash with Customizable Endurance