ISL21400 Evaluation Board ISL21400 Programmable Voltage Reference Evaluation Board User Guide USER’S MANUAL

2018-08-22
The ISL21400 evaluation board is designed to be connected to the Intersil ISLUSBCEVAL1Z evaluation board. There is a connector (USB Board) on the ISL21400 evaluation board which mates with the ISLUSB evaluation board.
The ISL21400 device is mounted on top of the board on a copper pad with vias to a copper pad on the bottom. This provides good thermal conductivity to the underside of the board. The surrounding area has copper on both top and bottom of the board in an area 0.375”x0.375”, with many vias for conducting heat from the underside of the board to the top side.
The ISL21400 evaluation board has all address pins shorted to ground; therefore, only slave address 50h can be selected.
The ISL21400 device on the board is powered by the 3.3V regulator from the ISLUSB evaluation board. If a different VCC is desired, please remove the J2 jumper on the ISLUSB evaluation board and connect the desired VCC to the VCCconnector on the ISL21400 evaluation board.


Renesas

ISL21400

More

Part#

Evaluation Board

More

More

User's Guide

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

May 12, 2009

Rev 1.00

AN1394

321 KB

- The full preview is over. If you want to read the whole 3 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: