Renesas RA8 Series Getting Started with RA8 Memory Architecture, Configurations and Topologies

2024-02-01
■Introduction
▼This application note is intended to provide details on how to best utilize memory resources of the RA8 family of devices. As MCUs move into higher complexities, the on-chip memory resources may not be sufficient to support the advanced requirements, so using off-chip memories, becomes a necessity needed as well to fully realize advanced applications using MCUs. RA8 devices have exhaustive on-chip memory in addition to supporting off-chip memory interfaces.
▼This application note includes:
●Description of the internal Flash and SRAM memory architectures included on RA8 devices.
●Description of the external memory interfaces, including how to interface to OSPI and the SDRAM/Memory bus.
●Instructions on how to connect memory devices to the OSPI and select each using chip select (CS).
●Instructions on how to configure and use the standby SRAM, including the significance of the standby SRAM in an application.
●Instructions on how to configure and use the Tightly Coupled Memory (TCM). Steps in the document to enable the user to choose the TCM.
●Description of ECC and Parity memory on RA devices and its configuration on RA8 devices.

Renesas

RA8 SeriesRA8RA8 familyRA8M1

More

Part#

MCUs

More

More

Application note & Design Guide

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

Nov.06.23

Rev.1.01

R01AN7088EU0101

5.2 MB

- The full preview is over. If you want to read the whole 58 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: