AN521: Introduction of AS500x Oscillator Frequency Stability
■The AS500x is a silicon-based reference clock generator. an LC oscillator (LCO) provides the clock input to a low-noise digitally controlled fractional-N frequency generator (FRAC-N); a driver block (DRV) with programmable multi-format outputs conditions the FRAC-N signal for export off-chip. The LCO if left uncompensated, is susceptible to changes in frequency due to environmental variables such as the ambient temperature, supply-voltage and humidity. Additionally, thermal stress incurred during solder-reflow causes large, relatively fast, thermal transients that can result in a frequency shift. This application note quantitatively describes the AS500x’s unique but predictable frequency-stability response relative to various environmental stresses and conditions. With the proprietary on-chip compensation scheme, AS500x maintains its output frequency within ±50 ppm of its target value over all such environmental conditions during the operating lifetime.
|
|
Application note & Design Guide |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
May 2021 |
|
Rev 1.0 |
|
AN521 |
|
1.1 MB |
- +1 Like
- Add to Favorites
Recommend
- Aeonsemi Introduced the High-Performance CMOS Programmable Oscillators, with Total Stability Better than ±50 ppm
- Aeonsemi Unveils Nemo™ Platform: Revolutionizing In-Vehicle Networking with Multi-Gigabit Ethernet
- Aeonsemi Achieves Key Milestone of Its Arcadium Silicon Oscillator Products, Shipping 10 Million Units Without any Defect
- Aeonsemi Unveils ChronoPHY™ Series of Multi-Rate 10G Ethernet PHYs Ethernet Transceivers, Integrating SyncE Jitter Filtering PLL Function
- SANYO DENKI Develops SANMOTION C S500 Series Motion Controller That Can Control 7-Axis Articulated Robots
- 7-Ch NMOS Transistor Array with 50V Output Voltage, Having Current Capability of 500mA per Channel
- At the time of setting sail, ACROVIEW Technology was awarded the recognition of Shenzhen‘s spec
- ept One27® SMT PCB Connectors with a Pitch of 1.27mm is Suitable for Board-to-board Applications ∣ video
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.