UPS-3000 Series UNINTERRUPTIBLE POWER SUPPLY
▲The SynQor UPS-3000 Series is an advanced technology military-grade uninterruptible power supply (UPS) that uses lithium polymer batteries and highly efficient power electronic circuitry to achieve a high power level and battery run-time in a low-profile, low-weight, rack-mountable package. It provides voltage and frequency conditioning, electrical isolation, and power flow smoothing between the power inputs and its power outputs. It provides battery backed-up power when other power sources are not present.
▲A communication/control port is available to permit monitoring and control by a host computer system. Front panel LEDs and an audible alarm provide information on the status of the UPS and the battery pack.
▲The UPS-3000 Series products can draw power from an AC input having a wide range of voltage and frequency levels, or from an optional 28 V nominal DC input. The AC input has priority over the DC input. The UPS provides up to 3000 VA and 2500 W of AC output power at 115 Vac. The pure sine wave AC output voltage can drive any non-linear load with a crest factor up to 2.5, and any load power factor from 0.0 to 1.0. There are two optional DC outputs at various voltage and power levels. The total AC plus DC output power is limited to 2500 W.
▲The electronic circuitry within the UPS-3000 Series products is designed, qualified and screened according to SynQor’s Mil-COTS Standards. It complies with the requirements of MIL-STD-704F, MIL-STD-1399-300B, MIL-STD-1275D and MIL-STD-461F, as well as IEC-EN61000 specifications for world-wide commercial utility applications.
▲The UPS-3000 Series products are designed and manufactured to withstand the harsh environments and use encountered in military applications.
▲The electronic circuitry and battery are contained in a sealed chamber constructed from a die-cast aluminum chassis that is weather-proof and shock-proof. Redundant, water-proof fans on the rear panel draw cooling air over the heat-sink fins below the sealed chamber. Military-grade circular connectors are used, and optional attached connector covers are available for when the cables are not attached. The UPS-3000 Series products comply with a wide range of testing according to MIL-STD-810G.
▲The UPS-3000 Series is a 2U high unit that has two standard battery packs which provide >10 minutes of full-power run-time and weighs approximately 65 lbs.
▲The SynQor UPS-3000 Series products are designed and manufactured in the U.S.A.
UPS-3000 Series 、 UPS-3000 、 UPS-3000-S-2U 、 UPS-3000-S-2U- 、 UPS-3000-S-2U-L1G6D28-E00 、 UPS-3000-S-2U-L2G5S00-E00 、 UPS-3000-S-2U-L2G5S00-ECE |
|
UNINTERRUPTIBLE POWER SUPPLY 、 advanced technology military-grade uninterruptible power supply (UPS) |
|
|
|
User's Guide |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
09/24/20 |
|
Rev V |
|
|
|
7.4 MB |
- +1 Like
- Add to Favorites
Recommend
- OWON Has Demonstrated its XSA1000 Series, OWP-H, SPE Series, XDM Series in the 2023 Hong Kong Electronics Show
- Silicon Labs Announces Next Generation Series 3 Wireless Platform to Create a Smarter, More Efficient IoT
- Shindengen Adds JH Series and MG038 Series Large Capacity Three Phase Bridge Diodes
- ONPOW New Series- ONPOW61 Push Button Switch With Connector that Covers 16mm, 19mm, 22mm, and 25mm in Diameter
- Conductive Polymer Hybrid Aluminum Electrolytic Capacitors 80V products added to the HXA/HXB Series Radial lead type HSA/HSB Series commercialized
- Yangtze Microelectronics Introduces Integrated Inductors FTC Series and FEXL Series with a Thickness of 0.55mm
- Nippon Chemi-Con Developed Snap-in Type Aluminum Electrolytic Capacitors RLB Series with High Ripple and RLA Series with Longer Life
- The Difference between LiMnO2 Button Battery CR Series and CR/PH Series
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.