Thermoelectric Coolers Handling, packaging & Ceramic Inspection

2022-05-31
●Handling
■It is important that the thermoelectric coolers are handled correctly. Improper handling could decrease performance and possible premature failure.
▲Never pull the leads up or to the side. If bending of the wire leads is required hold the heat shrink area which is close to the ceramic with fine nose plyers while supporting the module and bend at wire insulation only.
▲Avoid excessive lateral shear force when handling thermoelectric coolers this may induce damage to the thermoelectric element.
▲Sharp bend radiuses in the wire should be avoided and wires should be routed to avoid any sharp edges that could penetrate the wire insulation.
●Packaging
■When shipping and handling thermoelectric cooler products, it is important to use the correct container and methods. This has been tested to shipping standards and securely delivers material without breaking. Other packaging may not be suitable and cause material to break during transit, which makes it difficult for our Quality team to investigate.
▲For single unit size with dimensions <35mm and 21 < W2 ≤ 32mm product, use foam P/N 467033-02, put 12 pcs per layer, 5 layers per box.
▲For single unit size with dimensions <45mm and 32 < W2 < 40.5mm product, use foam P/N 467033-03, put 10 pcs per layer, put 5 layers per box.

Laird Thermal Systems

thermoelectric coolers

More

More

Application note & Design Guide

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

April, 2016

435 KB

- The full preview is over. If you want to read the whole 5 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: