DN1157 Electronic Cigarette (eCig) Design Note
The electronic cigarette (eCig) industry has grown dramatically over the last few years and the growth is expected to continue. Higher power eCigs require voltage and current control from an MCU and power switching using MOSFETs and gate drivers. In an eCig driver, the voltage may need to be stepped up (boost) or stepped down (buck). Figure 1 shows a typical boost arrangement that may be used in an eCig. When step up is needed, the MCU applies PWM to the boost circuit (Figure 1, to IN of the DGD2104A) and the output voltage (to buck) is higher than the battery voltage. When step down is needed, the Q1 is on 100% duty cycle providing the battery voltage to the buck (not shown) and the MCU provides PWM to the buck.
|
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
January 2016 |
|
Rev 1 |
|
DN1157 |
|
315 KB |
- +1 Like
- Add to Favorites
Recommend
- [经验]瑞萨32位MCU RA2E1如何利用FSP工具生成sci_uart的配置代码
- The Micro Inductor Supplier, Guangzhou Jinkai Electronics (CHK) and Sekorm Announced a Distribution Agreement
- Greenconn荣获邓白氏企业认证,实力彰显行业领先水平
- TeraSilIC‘s 24GHz mmWave radar sensor in smart washlets
- At IPC APEX Expo 2022 in San Diego,Ventec premiered ‘aerolam‘ in the US market,curated for aerospace & defense applications
- Ventec New launches flex-rigid material tec-speed 4.0 (VT-462(L) PP NF/LF) for critical military & aerospace applications
- The lowest power consumption with the smallest size: Terasilic‘s 24GHz radar AiM
- Types and functions of chip transistors
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.