ARP SERIES Alternating Relay
■ The ARP Series is used in systems where equal run time for two motors is desirable. The selector switch allows selection of alternation or for continuous operation of either load. LED’s indicate the status of the output relay. This versatile series may be front panel mounted (BZ1 accessory required) or 35 mm DIN-rail mounted with an accessory socket. Operation
■ Alternating: When the rotary switch is in the “alternate” position, alternating operation of Load A and Load B occurs upon the opening of the control switch S1. To terminate alternating operation and cause only the selected load to operate, rotate the switch to position “A” to lock Load A or position “B” to lock Load B. The LEDs indicate the status of the internal relay and which load is selected to operate.
■ Note: Input voltage must be applied at all times for proper alternation. The use of a solid-state control switch for S1 may not initiate alternation correctly. S1 voltage must be from the same supply as the unit’s input voltage (see connection diagrams). Loss of input voltage resets the unit; Load A becomes the lead load for the next operation.
■ Duplexing (Cross-Wired): Duplexing models operate the same as alternating relays and when both the Control (S1) and Lag Load (S2) Switches are closed, Load A and Load B energize simultaneously.
■ The DPDT 8-pin, cross-wired option, allows extra system load capacity through simultaneous operation of both motors when needed. Relay contacts are not isolated.
|
ARP SERIES 、 ARP 、 AR120A-3095 、 ARP23S 、 ARP41 、 ARP41S 、 ARP42S 、 ARP43 、 ARP43S 、 ARP61S 、 ARP62S 、 ARP63S |
|
|
|
|
|
Datasheet |
|
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
|
060216 |
|
|
Rev: 1-A-060216 |
|
|
|
|
|
537 KB |
- +1 Like
- Add to Favorites
Recommend
- Viking newly produced a High Power Thin Film Chip Resistors ARP series with Power rating of 1 W and Resistance range of 10 ~ 100KΩ
- Very Fast Acting Fuse PICO® II Fuse Series, Designed for Battery Management System | Littelfuse
- Littelfuse Launches Advanced and Easily Configurable Pre-engineered Fused Coordination Panels
- New Littelfuse 400PV Photovoltaic Fuses Provide Rugged Circuit Protection for Next-Gen Integrated Solar Shingles
- Littelfuse Completes Acquisition of C＆K Switches
- Littelfuse expands its fuse manufacturing operation in China, Cuting Customer Order Fulfillment Lead Time by Half
- Littelfuse Launches 1500 Volt Solar String Fuse and Holder Rated 35 to 60 Amperage
- Littelfuse Acquires Embed，Embedded software and firmware expands technical capabilities
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
