BT740 Development Kit

2020-10-26

This Quick Start Guide applies to the following part numbers:
●DVK-BT740-SA
●DVK-BT740-SC
There are two hardware variants (on board antenna and uFL connector for external) of the BT740Enhanced Data Module (BTv2.1specification) which interface with a host via an UART and one of two logical protocols.
There are two logical protocols called AT and MP. AT is very similar to the Hayes AT protocol found in traditional modems allowing control of one Bluetooth connection at a time. MP is a multipoint packet-based protocol which allows the management of multiple simultaneous connections.
The BT740 ship from Laird facilities with a factory default in AT mode with communications setting of 9600,N,8,1.
This guide covers the topics below on the BT740 which is preconfigured in AT mode at production. If you chose to convert the BT740 to Multi Point (MP)mode, follow the Convert Protocol section to switch protocol modes.

Laird

BT740

More

Part#

Development KitEnhanced Data Module

More

More

User's Guide

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

7 April 2013

v1.2

1.5 MB

- The full preview is over. If you want to read the whole 27 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: