RF-WM-3200B3 Low Power Wi-Fi Module

2021-06-07
●Description
■RF-WM-3200B3 Wi-Fi module is based on TI Cortex™-M4 core Wi-Fi SoC CC3200. It is of 63 pin, 17.50 mm x 20.50 mm, and 1.27 mm pitch LGA package, fully pin-to-pin compatible to TI CC3200MOD. This Wi-Fi module features the best-in-class low power consumption performance, integrates powerful crypto engine for fast and secured WLAN connections with 256-bit encryption, and supports WPA2 personal and enterprise security. This module complies with 2.4 GHz 802.11 b/g/n standards. Its TCP/IP stack that runs on chip supports up to 8 simultaneous TCP, UDP, or ROW sockets, or 2 simultaneous TLS v1.2 or SSL 3.0 sockets. It can run in Station, AP or Wi-Fi Direct™ connection modes. This module has integrated an SPI Flash, a sleep clock crystal, and a fast clock crystal. It supports a wide supply voltage range from 2.3 V to 3.6 V. It has a pin-out of peripherals of 8-bit parallel, I2S, SD/MMC, UART, SPI, I2C, ADC, DMA and GPIOs interfaces. It also comes with a preprogrammed data communication protocol over its serial port and an AT commands set to simplify customers’ operations on Wi-Fi configuration.
●Key Features:
■Wi-Fi CERTIFIED™ Chip
■Application microcontroller subsystem:
▲Arm®Cortex® -M4 core at 80 MHz-Embedded memory
◆256 KB RAM
◆External serial flash bootloader, and peripheral drivers in ROM
▲32-Channel Direct Memory Access (μDMA)
▲Hardware crypto engine for advanced fast security, including
◆AES, DES, and 3DES
◆SHA2 and MD5
◆CRC and Checksum
▲8-bit parallel cameral interface
▲1 multichannel audio serial port (McASP) interface with support for two I2S channels
▲1 SD/MMC interface
▲2 UARTs
▲1 SPI
▲1 I²C
▲4 general-purpose timers with 16-bit PWM mode
▲1 watchdog timer
▲4-channel 12-bit ADCs
▲Up to 27 individually programmable, multiplexed GPIO pins
■Dedicated external SPI interface for serial flash
■Wi-Fi network processor subsystem
▲Featuring Wi-Fi internet-on-a-chip™
▲Dedicated ARM MCU
◆Completely offloads Wi-Fi and internet protocol from the Application microcontroller
▲Wi-Fi and internet protocols in ROM-802.11 b/g/n radio, baseband, medium access control (MAC), Wi-Fi driver, and supplicant-TCP/IP stack
◆Industry-standard BSD socket APIs
◆8 simultaneous TCP or UDP sockets
◆2 simultaneous TLS and SSL sockets
▲Powerful crypto engine for fast, secure Wi-Fi and internet connections with 256-bits AES encryption for TIS and SSL connections
▲Station, AP, and Wi-Fi direct® modes
▲WPA2 personal and enterprise security
▲SimpleLink connection manager for autonomous and fast Wi-Fi connections
▲SmartConfig™ technology, AP mode, and WPS2 for easy and flexible Wi-Fi provisioning
▲TX power
◆18.0 dBm @ 1 DSSS
◆14.5 dBm @ 54 OFDM
▲RX sensitivity
◆-95.7 dBm @ 1 DSSS
◆-74.0 dBm @ 54 OFDM
▲Application throughput
◆UDP: 16 Mbps
◆TCP: 13 Mbps
■Power-Management Subsystem:
▲Integrated DC/DC converters support a wide range of supply voltage:
◆VBAT wide-voltage supply: 2.7 V ~ 3.6 V
◆VIO is always tied with VBAT
◆Preregulated 1.85 V mode
▲Advanced low-power modes:
◆Hibernate: 4 μA
◆Low-power deep sleep (LPDS): 250 μA
◆RX traffic (MCU active): 59 mA @ 54 OFDM
◆TX traffic (MCU active): 229 mA @ 54 OFDM, maximum power
◆Idle connected (MCU in LPDS): 825 μA @ DTIM = 1
■Clock source
▲40.0-MHz crystal with internal oscillator
▲32.758-KHz crystal or external RTC clock

RF-Star

RF-WM-3200B3RF-WM-3200B1RF-WM-3235B1RF-WM-3220B1RF-WM-3200B1IRF-WM-3200B2RF-WM-10AFB1CC3235SFRTL8710AFCC3235SCC3220RTL8711AFCC3200CC3200MOD

More

Part#

Low Power Wi-Fi Module

More

Cloud connectivity ]Home automation ]Home appliances ]Access control ]Security systems ]Smart energy ]Internet gateway ]Industrial control ]Smart plug ]Smart metering ]Wireless audio ]IP network sensor nodes ]

More

Datasheet

More

More

Please see the document for details

More

More

SMT

English Chinese Chinese and English Japanese

2020.01.19

V1.1

2.7 MB

- The full preview is over. If you want to read the whole 33 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: