RX113 Group Renesas MCUs Datasheet

PublishTime：2021-03-25

●32 MHz, 32-bit RX MCUs, 50 DMIPS, up to 512 Kbytes of flash memory, USB 2.0 full-speed host/function/OTG, up to 12 comms channels, serial sound interface, LCD controller/driver, capacitive touch sensing unit, 12-bit A/D, 12-bit D/A, RTC
●Features:
■ 32-bit RX CPU core
◆32 MHz maximum operating frequencyCapable of 50 DMIPS when operating at 32 MHz
◆Accumulator handles 64-bit results (for a single instruction) from 32-bit × 32-bit operations
◆Multiplication and division unit handles 32-bit × 32-bit operations (multiplication instructions take one CPU clock cycle)
◆Fast interrupt
◆CISC Harvard architecture with five-stage pipeline
◆Variable-length instruction format, ultra-compact code
◆On-chip debugging circuit
■ Low power consumption functions
◆Operation from a single 1.8 to 3.6 V supply
◆Three low power consumption modes
◆Low power timer (LPT) that operates during the software standby state
◆Supply currentHigh-speed operating mode: 0.11 mA/MHzSoftware standby mode: 0.44 μA
◆Recovery time from software standby mode: 4.8 μs
■ On-chip flash memory for code, no wait states
◆Operation at 32 MHz, read cycle of 31.25 ns
◆No wait states for reading at full CPU speed
◆128 to 512 Kbyte capacities
◆Programmable at 1.8 V
◆For instructions and operands
■ On-chip data flash memory
◆8 Kbytes1,000,000 Erase/Write cycles (typ.)
◆BGO (Background Operation)
■ On-chip SRAM, no wait states
◆32 and 64 Kbyte capacities
■ Data transfer controller (DTC)
◆Four transfer modes
◆Transfer can be set for each interrupt source.
■ Event link controller (ELC)
◆Module operation can be initiated by event signals without going through interrupts.
◆Link operation between modules is possible while the CPU is sleeping.
■ Reset and power supply voltage management
◆Six types including Power-On Reset (POR)
◆Low voltage detection (LVD) with voltage settings
■ Clock functions
◆External clock input frequency: Up to 20 MHz
◆Main clock oscillator frequency: 1 to 20 MHz
◆Sub-clock oscillator frequency: 32.768 kHz
◆PLL circuit input: 4 to 8 MHz
◆Low-speed on-chip oscillator: 4 MHz
◆High-speed on-chip oscillator: 32 MHz ±1% (–20 to 85°C)
◆USB-dedicated PLL circuit: 6 and 8 MHz
◆IWDT-dedicated on-chip oscillator: 15 kHz
◆Generate a dedicated 32.768-kHz clock for the RTC
◆On-chip clock frequency accuracy measurement circuit (CAC)
■ Realtime clock (RTC)
◆30-second, leap year, and error adjustment functions
◆Calendar count mode or binary count mode selectable
◆Capable of initiating exit from software standby mode
■ Independent watchdog timer (IWDT)
◆15-kHz on-chip oscillator produces a dedicated clock signal to drive IWDT operation.
■ On-chip functions for IEC 60730 compliance
◆Clock frequency accuracy measurement circuit, IWDT, functions to assist in RAM testing, etc.
■ Up to 12 channels for communication
◆USB: USB 2.0 host/function/On-The-Go (OTG) (one channel), full-speed = 12 Mbps, low-speed = 1.5 Mbps, isochronous transfer, and BC (Battery Charger) supported
◆SCI: Asynchronous mode, clock synchronous mode, smart card interface (up to eight channels)
◆IrDA interface (one channel, in cooperation with SCI5)
◆I²C bus interface: Transfer at up to 400 kbps, capable of SMBus operation (one channel)
◆RSPI: Up to 16 Mbps (one channel)
◆Serial sound interface (SSI) (one channel)
■ Up to 14 extended-function timers
◆16-bit MTU: Input capture/output compare, complementary PWM output, phase counting mode (six channels)
◆8-bit TMR (four channels)
◆16-bit CMT (four channels)
■ LCD controller/driver
◆Segment signal output × common signal output: 40 × 4, 36 × 8
◆On-chip voltage boost circuit, contrast adjustment, and 5-V panel supported
◆Blinking function
■ 12-bit A/D converter
◆Up to 17 channels
◆1.0 μs minimum conversion speed
◆Double trigger (data duplication) function for motor control
■ 12-bit D/A converter
◆Two channels
■ Comparator B
◆Two channels
■ Capacitive touch sensing unit (CTSU)
◆Detection pins: 12 channels (for 100 pins only)
◆High-sensitive electrostatic capacitance detection using self-capacitance and mutual capacitance methods
◆On-chip noise canceller that enables high tolerance to disturbance noise
◆Also supports a mutual capacitance method that allows touch channels to be increased with low pin counts
■ Temperature sensor
■ General I/O ports
◆5-V tolerant, open drain, input pull-up
■ Multi-function pin controller (MPC)
◆Multiple I/O pins can be selected for peripheral functions.
■ Unique ID
◆32-byte ID code for the MCU
■ Operating temperature range
◆–40 to +85°C
◆–40 to +105°C

Brand of Product：	Renesas
Part#：	RX113 Group 、 R5F51138AGFP#3A 、 R5F51138AGFP 、 R5F51138AGFM#3A 、 R5F51138AGFM 、 R5F51138ADLJ#2A 、 R5F51138ADLJ 、 R5F51138ADFP#3A 、 R5F51138ADFP 、 R5F51138ADFM#3A 、 R5F51138ADFM 、 R5F51137AGFP#3A 、 R5F51137AGFP 、 R5F51137AGFM#3A 、 R5F51137AGFM 、 R5F51137ADLJ#2A 、 R5F51137ADLJ 、 R5F51137ADFP#3A 、 R5F51137ADFP 、 R5F51137ADFM#3A 、 R5F51137ADFM 、 R5F51136AGFP#3A 、 R5F51136AGFP 、 R5F51136AGFM#3A 、 R5F51136AGFM 、 R5F51136ADLJ#2A 、 R5F51136ADLJ 、 R5F51136ADFP#3A 、 R5F51136ADFP 、 R5F51136ADFM#3A 、 R5F51136ADFM 、 R5F51135AGFP#3A 、 R5F51135AGFP 、 R5F51135AGFM#3A 、 R5F51135AGFM 、 R5F51135ADLJ#2A 、 R5F51135ADLJ 、 R5F51135ADFP#3A 、 R5F51135ADFP 、 R5F51135ADFM#3A 、 R5F51135ADFM 、 R5F51DFMA831#3A 、 RX113 More Part#
Product Category：	MCUs More
Application：	More
Data Type：	Datasheet More
Safety & Environment Standards：	More
Operating Temperature：	Please see the document for details
Qualification Grade：	More
Qualification Approval：	More
Package：	PLQP0100KB-A;PLQP0064KB-A;PTLG0100JA-A;LFQFP;TFLGA
Language：	English Chinese Chinese and English Japanese
Date of Creation：	Sep 07, 2020
Version Number：	Rev.1.20
Data Encoding：	R01DS0216EJ0120
Data Size：	4.2 MB

Data section preview(2pages)

- The full preview is over. If you want to read the whole 131 page document,please Sign in/Register -

Download

+1 Like
Add to Favorites

Recommend

New Products & Solutions

More>

Technical Resources

More>

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Integrated Circuits