ISL81801 80V Bidirectional 4-Switch Synchronous Buck-Boost Controller
The ISL81801 uses a proprietary buck-boost control algorithm with valley current modulation for Boost mode and peak current modulation for Buck mode control.
The ISL81801 has four independent control loops for input and output voltages and currents. Inherent peak current sensing at both ends and cycle-by-cycle current limit of this family of products ensures high operational reliability by providing instant current limit in fast transient conditions at either end and in both directions. It also has two current monitoring pins at both input and output to facilitate Constant Current (CC) limit and other system management functions. CC operation down to low voltages avoids any runaway condition at over load or short-circuit conditions. In addition to multilayer overcurrent protection, it also provides full protection features such as OVP, UVP, OTP, average and peak current limit on both input and output to ensure high reliability in both unidirectional and bidirectional operation。
Features:
● Single inductor 4-switch buck-boost controller
● On-the-fly bidirectional operation with independent control of voltage and current on both ends
● Proprietary algorithm for smoothest mode transition
● MOSFET drivers with adaptive shoot-through protection
● Wide input voltage range: 4.5V to 80V
● Wide output voltage range: 0.8V to 80V
● Supports startup into pre-biased rails
● Programmable frequency: 100kHz to 600kHz• Supports parallel operation current sharing with cascade phase interleaving
● External sync with clock out or frequency dithering• External bias for higher efficiency for 8V to 36V input
● Output and input current monitor
● Selectable PWM mode operation between PWM/DE/Burst modes
●Accurate EN/UVLO and PGOOD indicator• Low shutdown current: 2.7μA
● Complete protection: OCP, SCP, OVP, OTP, and UVP
■Dual-level OCP with average current and pulse-by-pulse peak current limit, also provides ■hort Circuit Protection (SCP)
■Selectable OCP response with either hiccup or constant current mode
■Negative pulse-by-pulse peak current limit
[ Battery backup ][ UPS/storage systems ][ Battery powered industrial applications ][ Renewable energy ][ Aftermarket automotive ][ Redundant power supplies ][ Robots and drones ][ Medical equipment ][ Building and industrial automation ][ Security surveillance ] |
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
TQFN,HTSSOP |
|
English Chinese Chinese and English Japanese |
|
Oct.16.20 |
|
Rev.1.01 |
|
FN8937 |
|
2.7 MB |
- +1 Like
- Add to Favorites
Recommend
- Renesas Unveils Boost and Dual-Phase Buck DC/DC Controllers ---- 80V Bidirectional Buck
- Renesas DSP Solution on Renesas Lab on the Cloud, Input Analog Signals Directly From A Signal Generator To The Rx231 Microcontroller Evaluation Board
- Renesas‘ Semiconductor Manufacturing Factory (Naka Factory) Fire: Production Capacity Has Recovered to 88%
- Renesas Announces 10 New Winning Combinations Integrating Celeno and Renesas Products
- Renesas & Altran to Deploy First Social Distancing Wristwatch Using Ultra-Wideband Chipset with Low Rate Pulse
- Renesas and FAW Establish Joint Laboratory to Accelerate Development of Next-Generation Smart Vehicles
- Renesas Semiconductor Manufacturing Factory (Naka Factory)‘ Production Level Has Returned to 100%
- Renesas and Sequans Expand Their 5G Collaboration including Broadband IoT Module for 5G NR FR1/FR2
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.