TMI8870K 1.5A Brushed DC Motor Driver
The TMI8870K devices feature integrated current regulation, based on the analog input VREF and the voltage on the ISEN pin, which is proportional to motor current through an external sense resistor. The ability to limit current to a known level can significantly reduce the system power requirements and bulk capacitance needed to maintain stable voltage, especially for motor startup and stall conditions.
The devices are fully protected from faults and short circuits, including UVLO,OCP, and TSD.
FEATURES:
●H-Bridge Motor Driver Drives One DC Motor, One Winding of a Stepper Motor, or Other Loads
●Wide 6.8V to 36V Operating Voltage
●1.5A Peak Current Drive
●LDMOS Rdson (HS+LS) 1.6Ω (typical)
●PWM Control Interface
●Integrated Current Regulation
●Low-Power Sleep Mode
●VM Undervoltage Lockout (UVLO)
●Overcurrent Protection (OCP)
●Thermal Shutdown (TSD)
●Automatic Fault Recovery
●ESOP8 Small Package and Footprint
[ DC Electric Fan Head-shaking Motor Driver ][ Aircraft Model Motor Driver ][ Printer ][ Monitor Equipment Motor Driver ] |
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
ESOP8 |
|
English Chinese Chinese and English Japanese |
|
2020.01 |
|
V1.0 |
|
|
|
839 KB |
- +1 Like
- Add to Favorites
Recommend
- Integrated DC Motor Driver: The Current Is Only 15μA In low-power Sleep Mode
- Stepper Motor Drivers with Built-in Micro-stepping Algorithm Solveing the Jitter and Noise Problems
- Benewake Offers A Low Cost Solution for Aunattended ETC Quick Toll Collection
- The “Magic Bullet“ for High-Current Scenarios, the Advantages of WAYON TOLL MOSFETs Explained
- At the front end of Data Short Range Communication 5.8GHz TAG/On Board Unit for Electronic Toll Collection
- QL Quartz Weigh-In-Motion Traffic Sensor Measures Accurately at The Speeds from 5 to 200km/h
- Learn About Electricity Meter RTC
- What Is an IoT Gateway and How to Overcome Challenges in IoT Gateway Applications
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.