PG-35H SMALL SIZE PRESSURE GAUGE
Important Information and Warnings:
①For stability, use a regulated direct current power supply. Surge absorbing devices(diodes, varistors, etc.)are necessary if inductive loads such as relays or solenoids are connected to the same circuit as the PG-35H. If using a DC power supply unit such as a switching power supply, the FG terminal should be earthed. Do not wire in parallel to high tension cables or power lines, or use cable ducts which contain high tension cables or power lines.
②Be careful not to crimp any wires during handling, or put any pressure on the display area of the main body while assembling piping.
③Use pH neutral detergents to clean the body. Do not use solvents such as thinners.
④This product is dust proof and drip proof（IP65 of IEC standards）and is not suitable for use in environments requiring higher standards. Also, do not use this product in an environment with a possibility of product being covered by liquids other then water（Such as oil, solvent, and etc.）and outdoor.
⑤Do not use pointed objects such as pens to press the setting buttons on the display panel, as this may push holes in the setting buttons and damage them.
⑥Do not insert wires, etc. in the pressure port, as this may damage the internal diaphragm and cause malfunctioning.
⑦The PG-35H series do not have an explosion proof structure. Do not use it for the detection of flammable gases.
⑧When analog output is supplied to a noise-sensitive device,a low-pass filter is requested in a customer's circuit.
⑨Countermeasures for noise interference: Please connect either the shield wire or the metal part of the product to frame ground（FG）of the power source.
⑩In case a wire extension is needed, please use a shielded wire.
|
PG-35H 、 ACPG-004 、 PG-30 、 PG-35 、 PG-35H-104R-NR2 |
|
|
|
|
|
User's Guide |
|
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
|
2020/06/19 |
|
|
Ver.3.2 |
|
|
|
|
|
702 KB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
