Maswell Has Recently Launched the 600-8000MHz Ultra-broadband High Gain 5g Mimo Panel Antenna Series for Cellular 5G Applications

PublishTime： 2022-11-10 Article Source：Maswell

MasWell has recently launched the 600-8000MHz ultra-broadband high gain 5G MIMO panel antenna series: AN_Master_001-2 MIMO and AN_Master_001-4 MIMO + GNSS triple cable version. The appearance of this antenna is demonstrated in Pic.1.

Figure 1 AN_Master_001-2 two cables version (left) and AN_Master_001-4 three cables (right)

Both 5G panel antenna models cover a frequency range of 600~8000MHz for cellular 5G applications. AN_Master_001-2 is a 5G / 4G / Wifi MIMO combined dual mode antenna. Both of the leads from this model support an independent Cellular/WiFi channel signals reception with an extremely wide bandwidth. Specifically, the supported frequency bands include all global 5G, 4G, 3G, GSM, LORA, Helium, and WiFi bands worldwide, such as WiFi Harlow, WiFi 2.4GHz, WiFi 5GHz, WiFi 6, WiFi 6E. The detailed S11 and VSWR performance of the antenna model is given in Fig.2 and Fig.3

AN_Master_001-4 antenna is equipped with three cables, which can simultaneously achieve dual 5G / 4G / WiFi Channels and 1 GNSS positioning signal coverage Channel. This GNSS channel supports all global GPS / GLONASS / Galileo / Beidou L1 band signal coverage and has incomparable advantages in high reliability and high redundant positioning.

Figure 2 The echo loss performance curve of AN_Master_001 series antenna in 5G dual circuit

Figure 3 The voltage standing wave ratio performance curve of AN_Master_001 series antenna in 5G

Typical radiation patterns of the AN_Master_001 panel antenna series at the low band (600-1800Mz), the middle band (2100-4800MHz), and the high band (5000-8000MHz) are shown in Figure 4-Figure 6. In such a wide frequency band, it is obvious that the antenna has a typical omnidirectional characteristic, covering a very wide area, and has almost no dead angle. Also, the gain of this antenna series of products is up to 7.5dBi, which demonstrates an outstanding signal reception capacity in an outdoor environment, especially in poor signal areas for Cellular MIMO functionality.

Figure 4 Typical radiation direction diagram of the AN_Master_001 series in low-frequency bands

Figure 5 Typical radiation direction diagram of the AN_Master_001 series in medium frequency bands

Figure 6 Typical radiation direction diagram of the AN_Master_001 series in high-frequency bands

Weatherproof and Dual installations for outdoor environment
The radome of AN_Master_001-2 and AN_Master_001-4 are made of high-standard ASA material with UV-stabilized capabilities. The material remains robust in harsh outdoor environments, such as storms, snow, dust, and strong solar radiation. The ASA material has the characteristics of low dielectric and low loss. Also, the ASA material strength is significantly better, compared with the common ABS antenna radome. These features make AN_Master_001-2 and AN_Master_001-4 outstanding for all weather conditions.

Figure 7 AN_Master_001 of the Install the application diagram

In terms of installations, the AN_Master_001 MIMO antenna series support both the outdoor direct screw installations, as well as the U-Bolt Pols, mounting. These two installation methods basically represent all the outdoor mounting possibilities for various applications. The detailed mounting instruction videos are demonstrated here: https://www.youtube.com/watch?v=QRoF81Mpna8

Extreme IP67 Waterproof test

The waterproof capabilities of this antenna series are remarkable. The antenna can maintain unaffected for 30 minutes under 1-meter-deep water. Unlike other models’ waterproof grade, which excludes the cable holes. The AN_Master_001 MIMO panel antenna IP 67 grade applies to the whole antenna body including the cable holes. Basically, this means the MIMO panel antenna can sustain any outdoor waterproof requirements during 24/7 hours. A demonstration video of the waterproof capacity is shown here：https://www.youtube.com/watch?v=kpFuZbrjBe0

Additionally, the 5G MIMO panel antenna has officially passed the IP 67 waterproof rating for EU standard EN 60529:1991+A1:2000+A2:2013+AC:2019 and China National Standard GB/T4208-2017.

Figure 8 AN_Master_001 IP67 certificate EN60529

Based on the description above, the AN_Master_001-2 and its derivative AN_Master_001-4 can support all the MIMO Cellular 5G 4G LTE, LORA, and Helium signals as well as all the WiFi bands from WiFi Harlow to WiFi 6E, due to its Ultra Wideband 600Mhz-8000MHz. The GNSS derivative version may operate under all the GNSS L1 bands for GPS, GLONASS, GALILEO, and Beidou. The dual installation methods enable the panel series to be mounted on all outdoor scenarios. The outstanding waterproof and weatherproof grade of the AN_Master_001 MIMO antenna series ensures its 24/7 operation capabilities under all weather conditions.

To further understand the performance of this range, download the data manually at:
https://www.maswelltech.com/index.php?m=content&c=index&a=show&catid=45&id=284
https://www.maswelltech.com/index.php?m=content&c=index&a=show&catid=45&id=283

Features

High Gain

Wide Band

Waterproof Grade: IP67

Radome with High Strength

Wide Radiation Range

Applications

5G, 4G, 3G Cellular Communication

Lora Communication

Wifi 6 Communication

IoT

MIMO Communication

CPE

Consumer Equipment

Intelligent Transportation Equipment

Indoor Signal Enhancement

Outdoor Signal Coverage / Reception

5G CPE

5G Gateway Devices

5G/4G Signal Booster

+1 Like
Add to Favorites

Recommend

Technical Resources

More>

New Products & Solutions

More>

This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.

Integrated Circuits