Automotive-grade TVS diode UATxP series, P600 package, used for load dump protection of vehicle power supply system
In automotive electronic systems, among the various pulses caused by different reasons, load dump is a common and more harmful phenomenon. The so-called load dump is when the car engine is running and the generator is delivering current to the car's power line. If the battery is suddenly disconnected, a higher surge voltage will be generated. It is characterized by high surge voltage, wide pulse width, and long duration. If it is not effectively protected, it will cause fatal damage to the circuit.
As shown in Figure 1, it is an intuitive simulation of the principle of load dump protection, which is realized by a dedicated load dump protection TVS on the power supply. If the circuit is not corrected for surge protection, it is easy to cause damage to the electronic devices in the circuit loop due to overvoltage. Since the maximum pulse width of the load dump surge is generally about 350-400ms, and the corresponding pulse peak voltage is also relatively high. The maximum voltage of the 12V system is as high as 87V, and the maximum of the 24V system is as high as 174V. Therefore, nominal TVS diode (designed and measured by 10/ 1000us pulse) cannot meet this protection requirements. A dedicated TVS for load dump protection needs to be connected in parallel to the power port. It can resist wide pulse surge (350 millisecond pulse width), and the power is relatively large and meets the requirements of vehicle regulations.
Figure 1:
In response to the load dump protection of vehicle power supply system,DA TECHNOLOGY has launched a Uni and Bidirectional Unit, wide-pulse power, automotive-grade TVS UATxP series.
Features
1. Designed specifically for load dump protection, can resist 350ms pulse power, P600 package
2. Easy prototype for EE designer,UATxP(x range from 2-4,means resistance according to ISO7637 benchmark,for example,UAT4P means it can help designer to pass ISO7637 174V/4Ω load dump requirements)
3. High peak current, stronger impact resistance;
4. Low leakage current, AEC-Q101 qualified
5. Competitive solution for load dump protection requirements.
- +1 Like
- Add to Favorites
Recommend
- The TVS protection array TPA3304P8 in the miniaturized DFN2626 SMD package of DA Technology used for RJ45, the line-to-line capacitance value is as low as 2pF
- The CC2XX series ceramic chip fuse of DA Technology has been successfully applied to the overcurrent protection of POS
- The CC2XX series ceramic chip fuse of DA Technology has been successfully applied to the over-current protection of electronic cigarettes
- The Cartridge fuse CA433 of DA Technology has been successfully applied in the overcurrent protection of the lithium battery formation system
- DA Technology SMD fuse SF303 is successfully applied to the overcurrent protection of PD charger
- The chip fuse SF303 of DA Technology has been successfully applied to the over-current protection of the AD sampling port of the electric motorbike
- DA Technology SMD big current fuse SF331 was successfully applied to the overcurrent protection of AGV
- DA Technology ESD protection array TPA143L05 applied to USB2.0 port protection
This document is provided by Sekorm Platform for VIP exclusive service. The copyright is owned by Sekorm. Without authorization, any medias, websites or individual are not allowed to reprint. When authorizing the reprint, the link of www.sekorm.com must be indicated.