Hammond ElectronicsAsia Inc.Diecast Aluminum Enclosures
●Features
■Rugged, diecast aluminum alloy (tough - yet easy to machine), electronic instrument enclosure.
■Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
■Unpainted version is vibra finished for a smooth surface with no sharp edges.
■Four (or 6 in 1590D, 1590DD & 1590E) 6-32 x 1/2" machine screws secure lid - into factory tapped holes.
■Designed to meet IP54.
■Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.
- +1 Like
- Add to Favorites
Recommend
- Greenconn New Launches GGAC203/CGAC203 Series Floating Board to Board Connectors with Stacking Heights of 20mm and 15mm
- Kinghelm‘s KH-GPS121204-WYCX GPS Antenna Ensures Stable Signal Reception with Its 50Ω Impedance and 1575.42MHz Frequency Range
- Vincotech‘s Sixpack Modules out Now: 1200V flowPACK 1 and flowPACK 2 delivering 75A and 150A
- Linear Voltage Regulator HM6220 Guaranteed 150mA Output and Offered Better than 1% Initial Accuracy
- Vincotech flowBOOST 1 sym - Featuring Infineon TRENCHSTOP™ IGBT5 Chips and Designed for 100A and 150A
- Single -channel High Speed 15 MBd CMOS optocoupler QX0720
- Introducing the RX MCU Product Longevity Program (PLP) That Goes beyond 15 Years of Support!
- SUPU Launches New Rail Switching Power Supplies, up to 93% Conversion Efficiency and 150% Power Margin
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.