Future Technology Devices International Ltd FT233HP/FT232HP(High Speed USB Bridge with Type-C/PD3.0 Controller)Datasheet
■Supports the USB-PD Specification Rev 3.0
■Port 1 supports Dual Role Power Function.
▲Initial sink on power up. Power role switchable to source after PD negotiation.
■Port 2 supports sink mode with charging function through to Port 1 (FT233HPQ only).
■Supports 5V3A, 9V3A, 12V3A, 15V3A, 20V3A PDOs as sink or source
■Supports up to 20 V/5 A (100 W) as a sink when attached to a PD source with 5 A certified type C cable
■Supports Fast Role Swap to switch from source to sink so that VBUS power will be uninterruptible
■Type-C/PD Physical Layer Protocol
■PD policy engine using 32-bit RISC controller with 8 kB data RAM and 48 kB code ROM
■PD mode configuration through external EEPROM
■Options to use external MCU controlling PD policy through I2C interface
■Single channel USB to serial/parallel ports with a variety of configurations
■Entire USB protocol handled on the chip. No USB specific firmware programming required
■USB 2.0 Hi-Speed (480 Mbits/s) and Full Speed(12 Mbits/s) compatible
■Multi-Protocol Synchronous Serial Engine(MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C (MASTER), SPI(MASTER) or bit-bang) design
■RS232/RS422/RS485 UART transfer data rate up to 12 Mbaud. (RS232 Data Rate limited by external level shifter)
■USB to asynchronous 245 FIFO mode for transfer data rate up to 8 Mbytes/s
■USB to synchronous 245 parallel FIFO mode for transfers up to 40 Mbytes/s
■Supports a proprietary half duplex FT1248 interface with a configurable width, bi-directional data bus (1, 2, 4, or 8 bits wide)
■CPU-style FIFO interface mode simplifies CPU interface design
■Fast serial interface option
■FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases
■Adjustable receive buffer timeout
■Option for transmit and receive LED drive signals.
■Bit-bang Mode interface option with RD# and WR# strobes
■Highly integrated design includes +1.2 V LDO regulator for VCORE, integrated POR function
■Asynchronous serial UART interface option with full hardware handshaking and modem interface signals
■Fully assisted hardware or X-On / X-Off software handshaking
■UART Interface supports 7/8-bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity
■Auto-transmit enable control for RS485 serial applications using the TXDEN pin
■Operational mode configuration and USB Description strings configurable in external EEPROM over the USB interface
■Configurable I/O drives strength (4, 8, 12, or 16 mA) and slew rate
■Low operating and USB suspend current
■UHCI/OHCI/EHCI host controller compatible
■USB Bulk data transfer mode (512-byte packets in Hi-Speed mode)
■+1.2 V (chip core) and +3.3 V I/O interfacing (+5 V Tolerant)
■Extended -40°C to 85°C industrial operating temperature range
■3 IC Package with RoHS compliant support:
▲FT233HPQ: Compact 64-pin Pb Free QFN package supports 2 PD 3.0 Ports
▲FT232HPQ: Compact 56-pin Pb Free QFN package supports 1 PD 3.0 Port
■Configurable ACBUS I/O pins
FT233HP 、 FT232HP 、 FT232H 、 FT233HPQ 、 FT232HPQ 、 FT232HPQ-TRAY 、 FT232HPQ-REEL 、 FT233HPQ-TRAY 、 FT233HPQ-REEL 、 FT232HL 、 FT232HQ 、 FT233H |
|
High Speed USB Bridge 、 Hi-Speed USB device 、 USB 2.0 Hi-Speed to UART/FIFO IC |
|
[ USB to FIFO ][ USB to FT1248 ][ USB to JTAG ][ USB to SPI ][ USB to I2C ][ USB to Bit-Bang ][ USB to Fast Serial Interface ][ USB to CPU target interface ][ USB Instrumentation ][ USB Industrial Control ][ USB EPOS Control ][ USB MP3 Player Interface ][ USB FLASH Card Reader ][ USB FLASH Card Writers ][ Set Top Box - USB interface ][ USB Digital Camera Interface ][ USB Bar Code Readers ] |
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
QFN;LQFP;QFN-64;QFN-56 |
|
English Chinese Chinese and English Japanese |
|
06-09-2024 |
|
Version 1.6 |
|
FT_001484 |
|
4.6 MB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.