Crystal Heat Transparent LCD Heater
■Standard Construction: Single 7 mil layer of transparent film coated with transparent layer of ITO coating on both sides of film.
■Sizes:1/2”x1/2” thru to16”x20”
■Borders: Minimum Busbar Width .100 inches. (It is desirable to have as wide a busbar as possible to avoid excessive drop in the busbars
■Cable and Connector: Heater can have lead wires to be terminated to a connector and be supplied with a miniature temperature sensor. All heaters are supplied with protective liners covering both sides.Dimensional Tolerances and Limits – Overall size +- .030inch for heaters less than 12” +-.100 inch for greater than 12” Lead Wire length +- .125 inch Thickness +- .005inch Printing +- .010 inch
●Performance Characteristics
■Light Transmission: 90% Visual Light Transmission
■Environmental Characteristics: Temperature Operating - -40 to +100c humidity 5-95% Temperature Storage - -40c to 100c humidity 5-95%
■Contact factory for environmental requirements outside the standard range
●Electrical Characteristics
■Input Voltage: 0-24 Volts DC or AC
■Wattage: 0.1 to1.0 watt/in is recommended
■Heater Resistance: Heater resistance is a function of desired heater wattage, available input voltage and heater geometry R= E2/w where e= input voltage and w=Desired wattage.For a rectangular shape of length “l” and width “W” the heater resistance is R= (SR) (W)/L SR = sheet resistance defined in ohms. Resistance of a square piece of conductive film regardless of its size. Available sheet resistance 10,30,60,80,200,300 ohms +- 20%
■Contact factory of other available resistant’s.
|
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
2011/9/20 |
|
|
|
|
|
36 KB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.