OPTO-4 SERIAL OPTO ISOLATOR

2024-09-24

●Isolate an RS232 (PC) port to protect against ground loops.

■The OPTO-4 provides a safe and low cost way of connecting an NMEA 0183 system to a PC or any other device with a standard RS232 9-pin port.

■As a bi-directional NMEA 0183 to RS232 interface cable, the OPTO-4 utilises OPTO-isolation to protect the PC input and spike protection for the PC output, providing comprehensive isolation of PC hardware when connecting to an NMEA 0183 bus.

■If isolation in both directions is required, the Actisense USG-2 offers bi-directional isolation in a USB to RS422 (NMEA 0183) form.

■The Actisense design integrates an over-moulded case for excellent water resistance and a small footprint for installation into tight spaces.

■The OPTO-4 takes power from the host RS232 signals including TX and the handshaking lines RTS and DTR, making the OPTO-4 suitable for most PC serial ports.

■In systems that cannot provide power on the handshaking lines, e.g. serial devices with only Rx and Tx lines, a DC power supply can be used.

■Note: Connecting an external power supply may create a ground loop between the PC port and the supply. Check that the supply ground is at the same potential as the PC ground before connecting.

■Please refer to the Quick Start Guide for detailed wiring instructions, including how to use an external power supply.

Actisense

OPTO-4

More

Part#

SERIAL OPTO ISOLATOR

More

More

Datasheet

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

2020/12/14

336 KB

- The full preview is over,the data is 2 pages -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: