E+E Modbus Probes with Beckhoff© - TwinCAT 2® DEVELOPER NOTE

2022-11-15
■Introduction
●This document describes how E+E probes with Modbus RTU interface are connected to Beckhoff hardware and how they communicate by means of TwinCAT. Only the properties specific to Modbus communication are described. Programmming knowledge in IEC 61131-3 under TwinCAT is required.
●This description is addressed to trained personnel of the control and automation technology that is familiar with the applicable national standards. For installation and commissioning of the components, the observance of the documentation and the following notes and explanations is absolutely necessary. For each installation and commissioning, the qualified personnel is obliged to use the documentation published at that time for each installation and commissioning. The qualified personnel must ensure that the application or use of the described products meets all safety requirements, including all applicable laws, regulations, provisions and standards.

E+E Elektronik

CX9020EL6021EL9010EE072EE872EE741

More

Part#

Modbus Probesinline flow meterCO₂ Probehumidity and temperature probeCompact CPUinterface terminalEtherCat end terminal

More

More

User's Guide

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

4/8/2020

v1.0

836 KB

- The full preview is over. If you want to read the whole 11 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: