Eaton® Hydrostatic Pumps Series 1 Models 33-64 Hydrostatic Variable Pumps Repair Information
●Most repairs require the removal of the pump from the vehicle.
●Cleanliness is extremely important.
●Clean the port areas thoroughly before disconnecting the hydraulic lines.
●Plug the pump ports and cover the open hydraulic lines immediately after they're disconnected.
●Drain the oil and clean the exterior of the pump before making repairs.
●Wash all metal parts in clean solvent.
●Use compressed air to dry the parts. Do not wipe them dry with paper towels or cloth; Lint in a hydraulic system will cause damage.
●The compressed air should be filtered and moisture free.
●Always use new seals when reassembling hydraulic pumps.
●For replacement parts and ordering information refer to parts list 6-608.
●Lubricate the new rubber seals with a petroleum jelly like Vaseline before installation.
●Torque all bolts over gasketed joints, then repeat the torquing sequence to make-up for gasket compression.
●Verifying the accuracy of pump repairs on an authorized test stand is essential.
|
33 、 39 、 46 、 54 、 64 、 Series 1 、 Models 33 、 Models 39 、 Models 46 、 Models 54 、 Models 64 、 0000 00 - 000 |
|
|
|
|
|
User's Guide |
|
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
|
January 2010 |
|
|
|
|
|
E-PUPI-TS013-E1 |
|
|
2.5 MB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
