KNX-USB:KNX–USB INTERFACE
●In the bus logging mode,the interface does not support communication with the ETS program.
●Features:
■communication with the KNX bus via integrated bus connector
■power supply from the KNX bus or from the computer USB port
■galvanic isolation of the KNX system and computer
■data transmission between the interface and the computer acc.to USB 2.0 standard
■LEDs indicating the device status
■easy to connect and use
|
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
2022/4/27 |
|
|
|
|
|
96 KB |
- +1 Like
- Add to Favorites
Recommend
- The Introduction of Global Navigation Satellite System-GNSS
- Taitien to Showcase Groundbreaking OCXO and TCXO Products at SATELLITE 2024
- Beidou Satellite Positioning Device Facilitates the Journey of Migratory Birds
- Keysight Launches Phased Array Antenna Control and Calibration Solution for Satellite Communications
- EASii IC Announces First Silicon for its DVB-S2X Satellite Modem ASIC EZID211, Which is Fabricated on a 40nm CMOS Low-power Process
- Nidec-Shimpo’s FLEXWAVE Precision Reducers are Adopted for Use in Communications Satellites’ Antennas
- Syrlinks Transmitter is Now Flying with StriX-1 Synspective Satellite
- YXC 12MHz Quartz Crystal Oscillator Is Used in Mobile Satellite Antennas, with A Frequency Difference of ±20ppm at Room Temperature
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.