How to Use the TIA Portal to Set a Siemens PLC and the MGate 5103 Tech Note
■The TIA Portal is Siemens's new software platform to configure and program S7-300/400/1200/1500PLCs. This technical note demonstrates how to configure the Siemens S7-300 to connect with the MGate 5103 in TIA Portal V14.
■The MGate 5103 supports a variety of maintenance functions, such as Protocol Diagnostics, Traffic Monitoring, Status Monitoring, and Fault Protection. The Status Monitoring function notifies a PLC/DCS/SCADA system when a Modbus device gets disconnected or does not respond. If a command has run successfully, the status bit's value will be 1. If a command has failed, the status bit's value will then be 0. In this case, the master device will be aware of the failure status of the slave device. When a PROFINET connection is disconnected, the Fault Protection function executes actions on end devices identified by a pre-defined value set by the user.
■This technical note also demonstrates how the PROFINET IO controller (Siemens PLC) receive these Modbus command statuses by sending PROFINET Acyclic Read commands, as well as how the Fault Protection function works.We also demonstrated how to use the Protocol Diagnostics and Traffic Monitoring functions for troubleshooting.
|
|
|
|
|
|
|
Application note & Design Guide |
|
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
|
2019/8/14 |
|
|
|
|
|
|
|
|
2.4 MB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
