Micron Optics, Inc. os3100 Strain Gage(Weldable) Installation Procedure
●Spot welding is the preferred method of mounting an os3100 gage to steel.A portable capacitive-discharge spot welder having 50 watt-seconds minimum energy rating is recommended for best results.The spot welder should be equipped with a small welding electrode having a spherical tip measuring approximately .030 inches [.76 mm] in diameter.It is often helpful to practice weld technique using a blank os3100 gage. Best results are usually obtained with a setting of 50 watt-seconds and firm pressure on the electrode. After making a practice weld, pull the gage off of the surface. A properly formed weld will result in a small piece of the surface or gage to break away. If needed, adjust the weld energy and electrode pressure until a satisfactory weld is obtained.(Contact Micron Optics for Welder recommendation).
|
|
|
|
User's Guide |
|
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
|
1/2007 |
|
|
Rev_C |
|
|
|
|
|
71 KB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
