16-bit registered driver with inverted register enable and 30 W termination resistors (3-state)
●General description
■The 74ALVC162334A is a 16-bit universal bus driver. Data flow is controlled by active LOW output enable (OE), active LOW latch enable (LE), and clock input (CP).
■WhenLE is LOW, the A to Y data flow is transparent. WhenLE is HIGH and CP is held at LOW or HIGH, the data is latched; on the LOW to HIGH transient of CP, the A data is stored in the latch/flip-flop.
■The 74ALVC162334A is designed with 30Ω series resistors in both HIGH or LOW output stages.
■When OE is LOW, the outputs are active. WhenOE is HIGH, the outputs go to the high-impedance OFF-state. Operation of the OE input does not affect the state of the latch/flip-flop.
■To ensure the high-impedance state during power-up or power-down,OE should be tied to VCC through a pull-up resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
●Features
■Wide supply voltage range of 1.2 V to 3.6 V
■Complies with JEDEC standard 8-1A
■CMOS low power consumption
■Direct interface with TTL levels
■Current drive: ±24 mA at 3.0 V
■MULTIBYTE flow-through standard pinout architecture
■Low inductance multiple Vcc and GND pins for minimum noise and ground bounce
■Output drive capability 50 transmission lines at 85 ºC
■Integrated 30 Ω termination resistors
■Input diodes to accommodate strong drivers
|
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
13 December 2006 |
|
Rev. 03 |
|
|
|
907 KB |
- +1 Like
- Add to Favorites
Recommend
- Types and functions of chip transistors
- CEO of Slkor and Kinghelm Sang Shiqiang‘s Interpretation of the “Domestic Substitution“ of the Electronic Information Industry
- SOSA Standards to Embedded Systems Development
- [经验]瑞萨32位MCU RA2E1如何利用FSP工具生成sci_uart的配置代码
- Keysight Gains Validation for First 3GPP Release 16 16/32 Transmitter Performance Enhancement Test Cases
- ept Colibri® 0.5 mm-pitch SMT Connectors Colibri® 0.5 mm-Pitch SMT Connectors: Maximum Flexibility with Data Transfer Rates of Up to 16 Gbps
- Keysight and Ettifos Successfully Conduct 3GPP Release 16 Sidelink Radio Conformance Test
- Keysight Secures First Release 16 Power Saving Test Case Validations
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.